Installation; Connect The Dap-1520 To Your Router Using Wps - D-Link DAP-1520 User Manual

Section 2 - Installation

Connect the DAP-1520 to Your Router Using WPS

The easiest and most secure way to connect your DAP-1520 to your router or access point is with WPS (Wi-Fi Protected Setup).
Refer to your user manual for your router or access point to make sure you understand how to enable WPS. Once you know,
follow the steps below:
Step.1.-
Find an available outlet near your wireless router. Plug in
the DAP-1520 and wait until the power LED is blinking
amber before continuing.
Step.2.- Press the WPS.button on your wireless router or access
point.
Step.3.- Within one minute, press the WPS. button on the
DAP-1520. The Power/Status LED will start blinking
green. When the LED turns solid green, the DAP-1520
is connected securely to your wireless router or access
point.
Step.4.- You can now unplug and move the DAP-1520 to a
location between your wireless router and the area where
you need to extend your wireless coverage.
D-Link DAP-1520 User Manual

Installation

9