Table of Contents
Advertisement
User Manual of Network Camera
Chapter 3 Parameter Configuration
There are several network parameters of the camera which need to be set after the hardware
installation. Those parameters including IP address, subnet mask and port number, etc. can be set
through various kinds of methods, 2 of which are introduced as below.
1. Set the camera parameters via IE.
2. Set the camera parameters through the client software.
Please make sure that the PC and network camera are connected and can ping successfully before
the parameter setting.
3.1 Visit Network Camera in LAN
There are two ways of connecting between IPC and PC as below:
Before visiting network camera, user should detect its IP address. SADP is a tool software which can
automatically detect hikvision's network device in the LAN and give the device's information like IP
address, mask, port number, device serial number, software version and so on.
Fig. 3.1.3 Cross Line Connection
Fig. 3.1.1 Direct Line Connection
16
16
Advertisement
Table of Contents
