Switching On; In The Event Of A Power Cut - Miele KM 3010 Operating And Installation Instructions

Operation

Switching on

In the event of a power cut

20
^ The control for the burner required must be pressed in and
turned anti-clockwise to the largest flame symbol to switch
on.
When a control is operated, a spark is produced on all
cooking zones. This is not a fault.
^ When the flame ignites, keep the control pressed in for
5-10 seconds, and then let it go.
^ If the flame goes out, turn the control to "ß". Wait for at least
one minute before trying again. If necessary keep the
control pressed in for longer.
^ If the burner does not ignite the second time, turn the
control to "ß", and see "Problem solving guide".
If there is an interruption to the electricity supply the gas can
be ignited with a match.
^ Press in the relevant control and turn it anti-clockwise to the
largest flame symbol.
^ Hold the control pressed in and light the gas at the burner
with a match.
^ Keep the control pressed in for a further 5-10 seconds and
then release it.