Equipment Connection; Operation - Panasonic CT-1388YD Operating Instructions Manual

Cable / Antenna (Cont.)
Antenna Connection
• For proper reception of VHF/UHF channels, an
external antenna is required. For best reception
an outdoor antenna is recommended.
• Antenna Mode must be set to TV.
Note: Cable mode is preset at the factory. Antenna users must change to antenna mode in Set Up menu.
O
PTIONAL
Video/Audio In & Out Connection
CT-1388YD, CT-1389VYD, CT-2088YD and CT-2089VYD
The IN and OUT terminals located on the back of Monitor directly pass the input signals through
the out terminals, so you may monitor or record the external Video/Audio information.

Operation

1. Connect an external Video/Audio source to VIDEO 1, VIDEO 2 or VIDEO 3 IN terminals, as
shown.
2. Select the same video mode that the equipment is connected to, by pressing the
TV/VIDEO or VIDEO SELECT button.
3. Connect a Monitor or VCR to the Video/Audio out terminals as shown. The out terminals
will provide the same signals as the input terminals for monitoring or recording.
Note: Video/Audio 1, 2 and 3 input and output terminals will operate whether the Monitor is ON or OFF.
VIDEO 3
AUDIO
IN
AUTO 75
S-VIDEO
IN
OUT
VIDEO
External Audio/Video Equipment
Incoming Cable from Home Antenna
E
QUIPMENT
VIDEO 2
AUDIO
Ω Ω
/HIGH AUTO 75 /HIGH
OUT IN OUT
VIDEO
Monitor
- 4 -
C
ONNECTION
MONITOR OUT
VIDEO 1
AUDIO
AUDIO
Ω
AUTO 75 /HIGH
IN OUT
VIDEO
VIDEO
VCR
OR