Preparing For Surround Sound; Speaker Settings - Kenwood 5.1 KRF-V7050D Instruction Manual

Preparing for surround sound

Speaker settings

To enable you to obtain optimum enjoyment from the receiver's listening
modes, make sure to complete the speaker settings (subwoofer, front,
center, and surround speakers) as described below.
MULTI CONTROL
POWER
ON/STANDBY
(KRF-V7050)
RC-R0720
1
Turn on the power to this receiver by pressing
POWER ( ) key.
2
Select a speaker system.
1 Press the SET UP key such that the subwoofer setting
indication "SUBW ON" appears.
SP A B TI.VOL
L C R
CLIP MUTE
LFE SW
RDS EON PTY
LS S RS
TP TA NEWS
2 Use the MULTI CONTROL knob or keys to select the appro-
priate subwoofer setting.
1 SUBW ON: Subwoofer setting mode to the receiver is ON.
2 SUBW OFF: Subwoofer setting mode to the receiver is OFF.
• The initial setting is "SUBW ON".
• When the setting "SUBW OFF" is selected, the front speakers are
automatically set to "FRNT LRG" and the procedure skips to step 5.
• When subwoofer output sound is required, select "FRNT NML".
3 Press the SET UP key to accept the setting.
• The front speakers setting indication "FRNT" appears.
SP A B TI.VOL
L C R
CLIP MUTE
LFE SW
RDS EON PTY
LS S RS
TP TA NEWS
4 Use the MULTI CONTROL knob or keys to select the appropri-
ate front speakers setting.
1 FRNT NML (normal): Average size front speakers are
2 FRNT LRG (large):
• For "FRNT LRG" selection, no sound will be heard from SUBW
even when it is set to ON. However, if you select CINEMA EQ when
subwoofer is selected, you will be able to hear sound from the
subwoofer.
When in STEREO mode, the sound goes directly to front speaker.
5 Press the SET UP key to accept the setting.
• The center speaker setting indication "CNTR" appears.
SET UP
SET UP
MULTI
CONTROL
RC-R0613
FM AUTO SOUND DIGITAL
AM PRO LOGIC S.DIRECT
MHz 3 STEREO MONITOR
kHz DOWN MIX DSP
FM AUTO SOUND DIGITAL
AM PRO LOGIC S.DIRECT
MHz 3 STEREO MONITOR
kHz DOWN MIX DSP
connected to the receiver.
Large front speakers are con-
nected to the receiver.
6 Use the MULTI CONTROL knob or keys to select the appropriate
center speaker setting.
If you selected "LRG" as the front speakers setting,
1 CNTR LRG (large):
2 CNTR NML (normal): An average size center speaker is con-
3 CNTR OFF:
If you have selected "NML" as the front speakers setting,
1 CNTR ON:
2 CNTR OFF: Center speaker setting mode to the receiver is
7 Press the SET UP key again to accept the setting.
• The surround speaker setting indication "SURR" appears.
8 Use the MULTI CONTROL knob or keys to select the appropriate
surround speaker setting.
If you selected "LRG" as the center speaker setting,
1 SURR LRG (large):
2 SURR NML (normal): Average size surround speakers are
3 SURR OFF:
If you have selected other than "LRG" as the center speaker
setting,
1 SURR ON:
2 SURR OFF: Surround speaker setting mode to the receiver
9 Press the SET UP key again to accept the setting.
AUTO
MEMO
ST.
• The receiver enters the speaker volume level adjustment mode.
TUNED
• In steps 3 and 4, indications appear only for the selected channels
of the speakers that require adjusting.
3
Adjust the speaker volume level.
From your usual listening position, adjust the volume levels. The
volume levels from each speaker should be the same.
1 Use the MULTI CONTROL knob or keys to adjust the volume
level of the test tone output from the speaker channel to be
adjusted.
The channel indication blinks while the test tone is being output.
SP A B TI.VOL
CLIP MUTE
RDS EON PTY
TP TA NEWS
AUTO
MEMO
ST.
The test tone is heard from the speakers in the following
TUNED
sequence for 2 seconds each:
• If you change the volume level settings for the speakers while listening
to music, the settings referred to on this page are also changed.
• If the speaker setting selects are OFF, the speaker level settings are
reset.
2 Press the SET UP key.
• The test tone is turned off. The receiver enters the mode for inputting
the distance to the speakers.
A large center speaker is connected to
the receiver.
nected to the receiver.
Center speaker setting mode to the
receiver is OFF.
Center speaker setting mode to the receiver is
ON.
OFF.
Large surround speakers are con-
nected to the receiver.
connected to the receiver.
Surround speaker setting mode to the
receiver is OFF.
Surround speaker setting mode to the receiver
is ON.
is OFF.
L C R
LFE
LS S RS
Continued to next page
19
FM AUTO SOUND DIGITAL AUTO
AM PRO LOGIC S.DIRECT MEMO
MHz 3 STEREO MONITOR ST.
kHz DOWN MIX DSP TUNED
•