Personalizing The Projector Menu Display; Locking Control Keys; Turning The Projector Off - BenQ W7000+ User Manual

Personalizing the projector menu display

The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do
not affect the projection settings, operation, or performance.
• Menu Display Time in the System Setup > Menu Settings menu sets the length of time the
OSD will remain active after your last key press. Use
• Menu Position in the System Setup > Menu Settings menu sets the OSD position in five
locations. Use
• Language in the System Setup menu sets your familiar language for the On-Screen (OSD) Menus.
See "Using the menus" on page 22
Splash Screen in the System Setup menu sets a preferred logo screen to be displayed during
•
projector start-up.

Locking control keys

With the control keys on the remote control and projector locked, you can prevent your projector
settings from being changed accidentally (by children, for example). When Key Lock is on, no control
keys on the remote control and projector will operate except POWER ON/OFF and
To lock the keys:
1. Press MENU and then press
2. Press to highlight Key Lock, and press
and press ENTER. The control keys lock.
To unlock the keys, press and hold

Turning the projector off

To turn the projector off, press POWER OFF on the remote
control to turn the projector off directly. Or you can press
the projector and a warning message appears. Press
• The Power indicator light flashes orange and the fans run for
about two minutes to cool the lamp. The projector will not
respond to any commands until the cooling process is complete.
• Then, the Power indicator light is a steady orange once the cooling process has finished and fans stop.
• If the projector will not be used for an extended period, unplug the power cable from the power
outlet.
• To protect the lamp, the projector will not respond to any commands during the cooling process.
Actual lamp life may vary due to different environmental conditions and usage.
38 Using the projector
/ to select a preferred position.
for details.
/ until the Advanced Setup menu is highlighted.
on the projector or remote control for 3 seconds.
http://www.pureglare.com.au
/ to select a suitable time length.
/ to select On. A warning message appears. Select Yes
on
I
I
again.
I
I
.