Advertisement
WINEGARD
®
MOTORIZED SENSAR ANTENNA
®
Model MA1000W
MADE IN U.S.A.
(Sensar
III head - U.S. Patent D500,496 and Patent Pending)
®
INSTALLATION MANUAL
CAUTION: This system is not for use with antenna in raised position
while vehicle is in motion.
Model MA1000W has white antenna head and white turret.
Unit packed as follows:
Motorized Mount with booms attached.
Antenna Head
Hardware Bag
Instructions
Antenna Power Supply
Coax Cable
Power Cable
Control Cable
Read Installation Instructions before installing unit.
Read Motorized Sensar Operation before operating unit.
1
Advertisement
Table of Contents
Related Manuals for Winegard MA1000W
Summary of Contents for Winegard MA1000W
-
Page 1: Installation Manual
® INSTALLATION MANUAL CAUTION: This system is not for use with antenna in raised position while vehicle is in motion. Model MA1000W has white antenna head and white turret. Unit packed as follows: Motorized Mount with booms attached. Antenna Head... - Page 2 Tools Needed/Specifications Tools needed for installation Tape measure 7/16" wrench Cutter 5/16" socket/nut driver Phillips screwdriver 1-1/2" to 3" hole saw (cable entry hole) Electric or cordless drill Sealant compatible with roof material (check with your vehicle manufacturer for compatibility) 1/8"...
-
Page 3: Pre-Installation Requirements
Pre-Installation Requirements To install the Winegard Motorized Sensar antenna, check with your RV dealer or manufacturer. Your RV may already be pre-wired for this system, and/or may have a reinforced Roof Edge FIGURE 3 roof area available. STEP 1: Choose location for antenna system on roof area. -
Page 4: Roof Installation
Cable Connector STEP 2: Winegard has included two options for routing the control and coax cables for the MA1000W. Option 1 is used to route cables below the base of the motorized sensar, Don't get where wires will be run through ceiling of the motor home. - Page 5 Step 2: Remove the three screws holding triangle-shaped sealant. Replace cover over cable area making sure O- cover with WINEGARD on it from antenna base. This plate Ring in in place. Snugly tighten the three cover screws, do will not be used. Locate cut-out triangle-shaped cover with not over tighten! See Figure 5.
- Page 6 Inside Installation Control Panel Installation STEP 1: Run control cable from roof mount to control panel. STEP 4: Control panel can be mounted directly to surface Do not connect to control panel at this time. providing surface has sufficient space behind panel for wiring. Should you be limited to space behind panel or choose not to STEP 2: Connect power cable to a fused 12VDC source.
-
Page 7: Warranty
If a defect in material or workmanship is discovered, Customer may take the product to an authorized Winegard dealer for service. Customer must provide proof of purchase to verify the product is under warranty. If the product is brought to an authorized Winegard dealer for service prior to expiration of year one (1) of the warranty period and a defect in material or workmanship is verified by Winegard Technical Services, Winegard Company will cover the Winegard dealer’s labor charges for warranty service. - Page 8 Printed in U.S.A. Winegard Company • 3000 Kirkwood Street • Burlington, Iowa 52601-2000 © Winegard Company, 2005 2452081...
Need help?
Do you have a question about the MA1000W and is the answer not in the manual?
Questions and answers