Exchange Method Of The Zoom; Gear Block Assy - Sony DSC-W200 Service Manual

2-2. EXCHANGE METHOD OF THE ZOOM (1210) GEAR BLOCK ASSY
Note: The lens should be retracted into the camera body before starting the work.
2-2-1. HOW TO REMOVE THE ZOOM(1210) GEAR BLOCK ASSY
1 Remove two screws, remove the zoom (1210) gear block assy.
2 Remove soldering from the two points and remove the flexible board from the D.C. motor.
3 Remove the claws at two locations by pushing two locations of the portion A of FG leaf spring in the direction of the arrow.
Then, remove the FG leaf spring.
4 Remove the sensors at two locations and remove the flexible board from the zoom (1210) gear block assy.
1 Screws
1 Zoom (1210)

Gear Block Assy

2-2-2. HOW TO INSTALL THE ZOOM(1210) GEAR BLOCK ASSY
1 Install the sensors to the new zoom (1210) gear block assy at two locations.
2 Install the FG leaf spring.
Note: Install the claw A and claw B in order.
3 Install the flexible board to the D.C. motor and solder at two locations.
4 Install the zoom (1210) gear block assy and tighten two screws.
*Tightening torque=0.049 0.01N m(0.5 0.1kgf cm)
1 New Zoom (1210)
Gear Block Assy
1 Sensors
2 FG Leaf
Spring
Claw A
Claw B
DSC-W200_L2
3 FG Leaf Spring
A
D.C. Motor
3 Solderings
2-6
4 Zoom (1210) Gear Block Assy
4 Sensors
Claws
D.C. Motor
2 Solderings
4 Screws
4 Zoom (1210)
Gear Block Assy