Kenwood DM-9090 Instruction Manual page 29

5
Adjust the digital source recording level.
1 Play the source to be recorded.
2 Press the ¶ key.
3 Adjust the recording level.
Set the REC MODE key to ON, select the
"D.REC LEVEL?" setting adjustment display
and vary the setting using the JOG DIAL.
6
Start recording.
Pressing the pause (8) key also allows to can-
cel record-pause mode and start recording.
7
Play the source to be recorded.
8
After recording, eject the Mini Disc.
During recording of a CD, the track number may be incremented by "1" at the moment the CD starts to play. This is caused by a signal
contained in the digital signal component of the CD. Unnecessary track numbers can be erased by following the procedure for "Erasing the
track being played (TRACK ERASE)."
8 ¶
8 ¶
0
÷ The unit enters record-pause mode automatically when the ¶ key is
pressed.
÷ Decrease the level if the red segments of the peak level meter light.
Recording is not possible if the following characters are displayed.
"DISC FULL" : Disc is full
\ Erase undesired tracks.
"001 UNLOCK" : The digital cord or optical fiber cable is not locked
in position or connected incompletely (or not
connected).
\ Connect the digital cord or optical fiber cable
properly.
"001 SCMS ON" : Digital recording is inhibited by SCMS.
\ Use analog recording.
"001 notAudio" : The digital signal being input is not an audio
signal.
\ Use analog recording.
"PROTECTED" : The accidental erasure protect tab is open.
\ Close it.
"PLAY ONLY" : The disc in use is a playback-only Mini Disc.
\ Use a recordable Mini Disc.
÷ When the EDIT / SPACE key is pressed during recording, a track
number is inserted in that position.
÷ The track number display (001 in the above) indicates the track where
the unit is put to record-pause mode.
÷ When recording is restarted after record-pause, the track number is
incremented automatically by "1".
÷ To play a track with a margin from the beginning, it is recommended to
start playing the source after the time display of the MD recorder has
started the count.
WRITING
Information is Mini Disc has been ejected.
being written.
÷ The eject (0) key is not accepted during recording.
While "WRITING" is displayed, do not apply shock
or vibration to the unit because information is
Note Note
being written on the Mini Disc.
Recording (DIGITAL input)
DM-9090 (En)
‚w
EJECT N O D I S C
29
0
§
§
7
9
‚