Cleaning The Radiator; If Engine Overheating Occurs; Radiator Hose; Hose Clamp - Mahindra 4010 HST Operator's Manual

5
-10
DIESEL ENGINE

IF ENGINE OVERHEATING OCCURS

If the coolant is overheated to around
or above boiling point, follow instruc-
tions below. If a warning buzzer or
lamp is turned on, follow instructions
below.
1. Safely stop the machine. Remove
any load from the engine and re-
duce the engine speed to idle.
2. Allow the engine to idle for 5 min-
utes before shutting it down.
3. After shutdown, allow the engine to
cool before troubleshooting and re-
pair. Stay away from an overheat-
ed engine until it cools as steam or
hot coolant may escape violently
without warning.
4. After shutdown, allow the engine to
cool before troubleshooting and re-
pair. Stay away from an overheat-
ed engine until it cools as steam or
hot coolant may escape violently
without warning.
5. After the engine cools, consult the
"Troubleshooting" section of this
manual to determine the cause.
Make repairs and adjustments as
required.

CLEANING THE RADIATOR

2

(1) Radiator Hose

(2) Hose Clamp

Clean the cooling system every 500
hours or as needed. Cleaning may
be required more often in severe ser-
vice conditions. Always clean the
system when replacing the engine
coolant.
IMPORTANT
Use water only to clean the ra-
diator core. Never use tools or
any other hard object that will
damage fi ns and tubes. Leaks
or degraded performance will
likely occur.
1
051O606B