Optional Control And; To Add Or Reprogram A Remote Control - Chamberlain LA400 Installation And Operation Manual

OPTIONAL CONTROL AND SAFETY DEVICES

To Add or Reprogram a Remote Control

1. Press and release "LEARN XMITTER" button (LED will light up).
2. Press and hold remote button, the LED will flash, alarm will beep twice and the LED will go out.
3. Repeat steps 1 and 2 until all remote controls are programmed (50 remote controls maximum).
NOTE: For highest level of security, we recommend the 315 MHz, Security ✚
R1
To Erase All Codes
To deactivate any unwanted remote controls, first
erase all codes:
Press and hold the "LEARN XMITTER" button on
logic board until the learn indicator light goes out
(approximately 6 seconds). All previous codes are
now erased. Reprogram each remote control or
keyless entry you wish to use.
LEARN
XMITTER
®
Remote Control
"LEARN XMITTER" Button
P2
CLOSE
EDGE
J19
14GP 89
14LG 89
14SK 89
OPEN/EGE
PHOTO
L1
1 S8
OFF ON SAVE
OFF ON MAGLOCK
OPEN
LEARN SINGLE DUAL MODE
PHOTO
XMITTER
NO NC EDGE
NO NC PHOTO
2
S1
CLOSE
PHOTO
24V
SWITCHED
ACCESSORY
OVLD POWER
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
27
line of products. Refer to Accessories.