Upgrading The Firmware - Kyocera FS-6525MFP Service Manual

1-6-1 Upgrading the firmware

1-6 Requirements on PWB Replacement
Follow the procedure to upgrade the firmware below.
* Main PWB (CTRL)
* DP main PWB (DP)
* PF main PWB (PF)
* DF main PWB (DF)
* Bridge PWB (AK)
* Engine IO PWB (IO)
Preparation
Extract the file that has the download firmware and put them in the USB Memory.
NOTE: To improve Firmware Upgrade speed, a separate SKIP file can be added to the USB Memory Stick
with the Firmware Upgrade package. The Skip file will allow ONLY the Firmware that has been
Upgraded to a New Version to load, skipping duplicate Firmware Levels.
Procedure
1. Turn ON the main power switch and
confirm if the screen shows "Ready to
print" then, turn OFF the main power
switch.
2. Insert USB memory that has the firm-
ware in the USB memory slot.
3. Turn ON the main power switch.
4. About 50 seconds later, "Farmware
Update" will be displayed (this shows to
start the download).
5. Display the software that now upgrad-
ing.
CTRL → DP → PF → DF → AK → IO
→ ENGN → FAX → OPT → DIC →
PANL
SAMPLE:
=================
Firmware Update
CTRL
xxx%
=================
Caution:
Never turn off the power switch or remove the USB flash device during upgrading.
6. Display the completion of the upgrade.
7. ROM version is confirmed by the content of the display.
8. Turn OFF the main power switch and remove the USB memory.
* Engine PWB (ENGN)
* FAX PWB (FAX)
* Language data (OPT)
* Dictionary data (DIC)
* Operation panel PWB (PANL)
The first line: Display shown while updating it
The second line: Display that shows update object
The third line: The progress of the update is displayed with %.
1-6-1
USB memory slot
USB memory
Figure 1-6-1
2MW/2MX