Attenuator; System Q; Audio Control - Kenwood DPX501U Instruction Manual

General features

Attenuator

Turning the volume down quickly.
Press the [ATT] button.
Each time you press the button, the Attenuator
turns ON and OFF.
When the Attenuator is ON, "ATT" is displayed.

System Q

Selecting the best sound setting preset for
different types of music.
1
Select the source to set
Press the [SRC] button.
2
Select the Sound type
Press the [Q] button.
When you press the button once, the current
sound setting is displayed.
Each time you press the button, the sound
setting alternates.
Sound setting
User memory
Rock
Pops
Easy
Top 40
Jazz
Natural
• User memory: The values set on the <Audio Control>
(page 12).
• Change each setting value with the <Speaker
Setting> (page 14).
First, select the speaker type with the Speaker setting.
12
|
English

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Basic Audio item
Turn the [VOL] knob.
Adjustment Item
Rear Volume *
Subwoofer level*
Bass level*
Middle level*
Treble level*
Balance
Display
Fader*
"USER"
Exit Audio Control mode (Volume control mode)
"ROCK"
"POPS"
"EASY"
• *
"TOP 40"
"JAZZ" • *
"NATURAL"
• *
• *
• *
• *
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob and
[ATT] button.
Display
1 "Rear Volume"/
"R-VOL"
2,3,4
"Sub-W Level"/
"SW L"
5 "Bass Level"/
"BAS L"
5
"Middle Level"/
"MID L"
5 "Treble Level"/
"TRE L"
"Balance"/ "BAL"Left 15 — Right 15
4
"Fader"/ "FAD" Rear 15 — Front 15
1
You can control this item when "2 ZONE"/ "2ZON" of
<Audio Setup> (page 14) is set to "ON".
2
You can control this item when <Switching preout>
(page 37) is set to "SWPRE SW". (DPX501U only)
3 You can control this item when <Subwoofer
Output> (page 15) is set to "SW ON".
4 You can control this item when "2 ZONE"/ "2ZON" of
<Audio Setup> (page 14) is set to "OFF".
5
You can adjust these items in detail. Refer to
<Adjusting the detail of Audio Control>(Page13).
5
Source tone memory: Puts the set up value in the
memory per source. (Detail Audio item is included)
Range
0 — 35
–15 — +15
–8 — +8
–8 — +8
–8 — +8