Kenwood DPF-R3010 Instruction Manual page 5

SYSTEM CONTROL CONNECTIONS
Connecting system control cords after connecting a KENWOOD
audio component system lets you take advantage of convenient
system control operations.
There are two KENWOOD system control modes. Make connec-
tions according to the groups of terminal symbols shown below.
lets you combine F , f, and ƒ terminals
[XS 8] Mode :
[SL16] Mode : for
This unit is compatible with both [XS8] and [SL16] modes.
Select the mode according to the connected components.
j
SL16 XS 8
÷ Do this operation after completing all connections.
(Ensure that the unit is set to STANDBY mode.)
Notes Notes
1. If your amplifier or receiver does not have a system control terminal, do not
connect any system control cords to the system control terminals on the other
components.
2. Do not connect system control cords to any components other than those
specified by KENWOOD. It may cause a malfunction and damage your
equipment.
3. Be sure the system control plugs are inserted all the way in to the system
control terminals.
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit with the system remote control unit supplied with the amplifier or receiver.
Automatic Operation (Except [XR] equipment)
Automatically switches the input selector on the amplifier or receiver when you start playback from this unit.
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from a CD. Also, the simple CCRS operation enables great recordings from
CDs.
See the operating instructions supplied with your cassette deck for details.
Adjusting the output levels of the output jacks
and headphone output (Except for CD-203/DPF-
R3010)
The OUTPUT level (UP/DOWN) keys of the remote control
unit can adjust the output levels from the LINE/OUT and
PHONES jacks of the unit.
REMOTE CONTROL UNIT
RC-P0601
÷ It is not favorable for the sound quality to decrease the output level from
this unit too much. Use these keys for coordination with other line
levels.
÷ Adjusting the headphone output level also changes the LINE/OUT
level. Do not adjust the output level from this unit particularly during
recording.
÷ Please note that the sound output is at the maximum level when the
power is turned on.
terminals only
4
OUTPUT
DOWN UP
CD-206/204/203/DPF-R6010/R4010/R3010 (En)
SYSTEM
CONTROL
SYSTEM
CONTROL
SYSTEM
CONTROL
To use the headphone (Except for CD-203/DPF-
R3010)
Connect a stereo headphone to the PHONES jack of the CD
player. Adjust the sound volume using the remote control
unit.
CD-206/DPF-R6010
O T U P T U
CD-204/DPF-R4010
_ 1 2 d b
Output level
System connections
Amplifier or receiver
This unit
Cassette deck
Output level
- 1 2 B d
1 2 3 4 5
6 7 8 9 10
5