Klne; Klne (Solartec And Sunteams) - Solar-Log Inverter Installation Manual

41 KLNE

41�1 KLNE (Solartec and Sunteams)
Easy Installation Termination
No
Overview
•
Integrated interface
•
Where to connect: 4-pin round socket on the button of the device
•
2-pin wiring
•
Communication address must be allocated.
•
Installation steps
• Switch off the inverters and Solar-Log™
• Connect inverters to the Solar-Log™
• Connect the inverters to each other
• Allocate communication addresses
Connect inverters to the Solar-Log™
The wiring is done using a
•
self-made cable connection with terminal block connector.
•
Where to connect: 4-pin round socket on the button of the device
Procedure
1. If you are making the cable yourself, connect the wires as shown in the following diagram:
Solar-Log™ terminal strip connector
Terminal
► 1
► 4
2. If only one inverter is to be connected, according to the manufacturer's handbook it must be
terminated.
3. Insert the terminal block connector into the Solar-Log™ RS485 socket.
Connect the inverters to each other
•
Where to connect: 4-pin round socket on the button of the device
Procedure
1. Unscrew the side cover as shown in the inverter's instructions.
2. If you are making the cable yourself, connect the wires as shown in the following diagram:
Addressing
Yes Yes
X4 socket inverter
PIN
4 - Data+
2 - Data-
Sensors RS485 Meters RS485
Yes

KLNE (Solartec and Sunteams)

Interface
Yes RS485
KLNE
125