Synchronize Clock; Selectable Illumination; Display Illumination Control; Dimmer - Kenwood KDC-W7037 Instruction Manual

In Standby mode

Synchronize Clock

Synchronizing the RDS station time data and this
unit's clock.
Display Setting
"SYNC : ON" Synchronizes the time.
"SYNC : OFF" Adjust the time manually.
⁄
• It takes 3 to 4 minutes to synchronize the clock.
In Standby mode
DSI (Disabled System Indicator)
A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
Display Setting
"DSI : ON" LED flashes.
"DSI : OFF" LED OFF.
In Standby mode

Selectable Illumination

Selecting the button illumination color as green or
red.
Display Setting
"Button : Red" The illumination color is red.
"Button : Green" The illumination color is green.

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function is
effective when you are driving at night.
Display Setting
"Display : ON" Keeps the display on.
Turns off the display when you perform no
"Display : OFF"
operation for 5 seconds.
⁄
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 35) is set to OFF.
• When the display is off, pressing any key will turn on the
display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Turning off the power
• During function control, such as the Menu System, the
display stays on.
In Standby mode

Dimmer

Dimming this unit's display automatically when the
vehicle light switch is turned ON.
Display Setting
"Dimmer : ON" The display dims.
"Dimmer : OFF" The display doesn't dim.
|
29
English