Table of Contents
Advertisement
Available languages
Available languages
Connecting Wires to Terminals
AUX input (Stereo)
Use the mini-plug cable which is stereo type and
does not have any resistance.
Front side
Wiring harness
(Accessory1)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Power control/Motor antenna control wire
(Blue/White)
Mute control wire (Brown)
Not Used (Blue)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
CA-U1EX
(Optional accessory)
USB connector
Fuse (10A)
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
P.CONT
Connect to the terminal that is grounded when either the telephone rings
MUTE
or during conversation.
⁄
ANT.
CONT
Car fuse box
ACC
FM/AM antenna input
Front output
R
L
(KDC-MP345U only)
Rear output/ Sub Woofer output
To connect the Kenwood navigation system, consult your navigation
manual.
Ignition key switch
Car fuse box
(Main fuse)
Battery
19
|
English
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the KDC-MP345U and is the answer not in the manual?
Questions and answers
Can’t get it out of the demo mode
To exit demo mode on the Kenwood KDC-MP345U:
1. Turn on the unit by pressing the [SRC] button.
2. When the message “CANCEL DEMO”, “PRESS”, “VOLUME KNOB” appears (within about 15 seconds), press the [VOL] (volume knob).
3. When “YES” is displayed, press the [VOL] knob again to confirm.
If “NO” is displayed, turn the [VOL] knob to change it to “YES” before pressing the knob.
This answer is automatically generated