Installer Modes - FBII XL-2T Installation And Setup Manual

XL-2T Installation & Setup Guide
DOOR STRIKE: # 9
The door strike trigger can be activated as follows:
If all users have been authorized for door strike (see question 08, location 3) then any valid
user code can activate a door strike trigger. If the "all users" option has not been selected
then user number 13 is the only user code authorized to activate the door strike.
NOTES:
(1) The trigger number (1 or 2) is only necessary if there is more than one trigger
(2) At least one of the triggers must be defined as a door strike trigger in order to use
U L
DOOR STRIKE is not a permitted programming option for any UL installation.
USER ON-LINE DOWNLOAD: # CODE
If programmed, by pressing # CODE buttons on the keypad, the user initiates a remote
communications session with the CS Downloading computer at the control station location.
On-line Downloading allows the user to call the office, discuss the action required and allows
the CS operator to complete the request while on-line with no additional telephone call
needed. On-line connection is be made as follows:
1. User dials the CS Downloading modem telephone line from the premise telephone.
Connection is made with a person at the CS Downloading computer and the account to be
downloaded is verbally identified. The CS computer is placed into a mode in which it
attempts to establish a connection with the site.
2. Next, the user will be instructed to enter # CODE on the keypad which causes the control
panel to behave as if it had received a request for a remote communications session and
looks for the standard panel-to-CS protocol.
3. Once the standard connection is made, the remote communications session can take place
(upload, download, remote commands).

Installer Modes

There are 9 installer modes in this panel.
where:
INSTALLER MODE 1 (INSTALLER KEYPAD PROGRAMMING)
Enters the installer into keypad programming mode. Refer to the Keypad Programming
Section of this Manual. To exit, simply press the STAY key and return to the prior panel
status.
5–8
programmed for door strike capability.
this feature.
TO ENTER INSTALLER MODES, press [CODE] [ ] [INSTALLER] [X]
[CODE] Press the CODE button
[ ] Press the star ( ) button
[INSTALLER] Enter the 4 digit installer code (default = 2468)
[X] Press the single digit indicating the installer mode as follows:
1 INSTALLER KEYPAD PROGRAMMING
Press 1 & 3 (at the same time) SYSTEM DEFAULT
Press 7 & 9 (at the same time) USER CODE DEFAULT
2 WALK TEST WITH SOUNDER
3 WALK TEST WITH SOUNDER AND BELL
4 SYSTEM LOG VIEW
5 WALK TEST MOTION
6 Not Used - RESERVED
7 SYSTEM DEFAULT
8 UNATTENDED DOWNLOAD
9 ON-LINE DOWNLOADING
# 9 [USER] [TRIGGER NUMBER]