Troubleshooting - Blaupunkt BP2914HD Instruction Manual

Troubleshooting

If you have any issues or queries about the functions of this TV, please check the below table as we have provided you with
FAQs to assist with any issues or visit our FAQ page online at www.blaupunkt-australia.com.au If this table is not of
assistance, please contact the BLAUPUNKT WARRANTY line on 1300 055 518.
Issue
No power
No picture
No sound
Colour distortion
Remote control is
not responding
Screen glittering
under PC mode
Screen traversed
under PC mode
Note:
This is an integrated design, Do NOT open the cabinet as it will cause panel damaged.
Solution
Turn off the unit at the remote and at the wall socket. Pull out the power plug. Wait
60 seconds and then plug the power cord back in, turn the power and unit back on.
Check that your cables and antenna have been connected firmly.
Check that your Picture Settings are correct.
Conduct a restore setting to return settings back to the factory default.
Check that your audio cables have been connected firmly.
Check that Muted Audio is not on and that Audio Settings are correct.
Conduct a restore setting to return settings back to the factory default.
Ensure that the equipment is connected properly.
Ensure that the AV video signal Input is connected properly.
Check the batteries and make sure there are no obstacles in the way of the remote
control and the sensor on the television.
Move closer to the remote sensor.
Using a digital camera (such as an iPhone camera) point the remote control facing
the camera from about 10 cm away. If you see a purple flash each time you press
the remote control then your remote control is working.
Reset the computer and enter the safety mode, then select the appropriate screen
type by consulting the PC operation manual.
The phase is not appropriate. Enter the PC's settings and change to the correct
level.
- 28 -