Trouble Shooting Guide - Dimplex RXPW4 Operating Manual

This displays the
current time. Time is
set by selecting
and using the – and
+ buttons to adjust.
Press "OK" to
confirm
This indicates the
current mode for
each zone.
1 bar = Setback
Mode
4 bars = Comfort
Mode
Mode Selector Mark.
Line up the symbol on
the mode selector
knob to the dot to
select mode.

Trouble Shooting Guide

If you have no heat from your heaters first
check they are switched on both at the wall
and on the heater.
Next make sure the Wall Controller has the
Mode Selector Knob in the correct position
(to test put it in the Comfort Mode).
Remember if the temperature setting on your
DuoHeat is not function or responding it is
likely that the Wall Controller is not in a
Comfort Mode. You can check this by looking
at the display on the Wall Controller you
should see 4 bars lit above the zone indicator,
any other display on the screen would indicate
you are not in Comfort Mode. Remember
when in Auto Mode your system will change
between Comfort Mode & Set Back Mode
depending on the time. It is Pre – set to be in
Comfort Mode between 8AM & 10AM – 3PM
& 9PM. If there is no display on the controller
contact your house manager.
This displays the day of
the week day 1 = Monday.
Adjust in the same way as
the Time. Tip hold down
the – and + buttons to
scroll through time in
greater increments.
Modification Buttons for
adjusting times.
Modification Buttons for
confirming adjustments.
This is also the Holiday
Mode function. Press & hold
for 5 seconds, display shows
"AB01" use the - and +
buttons to select the amount
of days you are away. The
days will automatically count
down and switch back to
Auto Mode for your return.
Should you return earlier
than expected just turn the
mode selector knob to
Comfort Mode and then
back to Auto Mode to
reset.
Mode Selector Knob
select to override into
Comfort Mode
select Auto Mode to
run on pre set times
select to override into
Set Back Mode
select to override into
Holiday/Frost
Protection Mode
select to switch
system off
select to adjust clock
and day of the week
select this mode to
change the pre-set
times of operation
Configuration options
for installer use only