Table of Contents
Advertisement
Site Preparations
The S4810–ON is suitable for installation as part of a common bond network (CBN).
You can install the system in:
•
network telecommunication facilities
•
data centers
•
other locations where the National Electric Code (NEC) applies
For more information about S4810–ON specifications, refer to Specifications.
NOTE: Install the S4810–ON system into a rack or cabinet before installing any optional
components.
Site Selection
Install Dell Networking equipment in restricted access areas.
A restricted access area is one in which service personnel can only gain access using a special tool, lock,
key or other means of security and access is controlled by the authority responsible for the location.
Ensure that the area where you install your S4810–ON system meets the following safety requirements:
•
Near an adequate power source. Connect the system to the appropriate branch circuit protection as
defined by your local electrical codes.
•
Environmental temperature between 32° to 104°F (from 0° to 40°C).
•
Relative humidity that does not exceed 85 percent noncondensing.
•
In a dry, clean, well-ventilated and temperature-controlled room, away from heat sources such as hot
air vents or direct sunlight.
•
Away from sources of severe electromagnetic noise.
•
Positioned in a rack or cabinet, or on a desktop with adequate space in the front, rear, and sides of the
S4810–ON for proper ventilation and access.
Cabinet Placement
Install the S4810–ON only in indoor cabinets designed for use in a controlled environment.
Do not install the S4810–ON in outside plant cabinets. For cabinet placement requirements, refer to
Selection.
The cabinet must be a minimum cabinet size. Airflow must be according to the Electronic Industries
Alliance (EIA) standard. Ensure that there is a minimum of 5 inches (12.7 cm) between the intake and
exhaust vents and the cabinet wall.
Site Preparations
3
Site
11
Advertisement
Table of Contents
