Prestige APS-25E Owner's Manual
  1. Manuals
  2. Brands
  3. Prestige Manuals
  4. Car Alarm
  5. APS-25E
  6. Owner's manual

Prestige APS-25E Owner's Manual

3 button remote security system
Hide thumbs Also See for APS-25E:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Table Of Contents:
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry
Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including any interference
that may cause undesired operation.
Warning!
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment
NOTE:The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modifications
could void the user's authority to operate the equipment
PATENTED: www.voxxintl.com/company/patents
Model APS-25E
3 Button Remote Security
System Owner's Manual
Page 1
Page 2
Page 3 - 4
Page 4
Page 4
Page 4
Page 5
Page 5
Page 5
Page 6
Page 6
Page 7
Page 7
Page 8
128-9321
Page 1/8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the APS-25E and is the answer not in the manual?

Questions and answers

Related Manuals for Prestige APS-25E

Summary of Contents for Prestige APS-25E

  • Page 1 Model APS-25E 3 Button Remote Security System Owner's Manual Table Of Contents: Introduction Features and Options Page 2 Arming The System Page 3 - 4 Protection While Armed Page 4 Disarming Your System Page 4 Intrusion Signals Page 4 Valet Override, Programming & Safety Control Switch...
  • Page 2  RF Inhibit with Ignition On  Parking Light Flasher  Plug In Dual Stage Shock Sensor OPTIONS:  Remote Trunk Release  Remote Keyless Entry  Multiple Vehicle Capable  Remote Starter  Remote Power Window Roll Up PRESTIGE Page 2 128-9321 Page 2/8...
  • Page 3 ARMING THE SYSTEM: (ACTIVE) 1. Turn off the engine, exit the vehicle, and close and lock all doors, hood and trunk. 2. Press and release the Lock button on the keychain transmitter. The siren will "chirp" once, the vehicle's parking lights will flash once, the doors will lock (optional) and the dash mounted LED will begin to slowly flash.
  • Page 4 PROTECTION WHILE THE SYSTEM IS ARMED: 1. Opening any door, hood or trunk will cause the alarm to immediately sound. The siren will continue to sound for 30 seconds, then stop and automatically re-arm the vehicle. If the potential thief left a door opened, the siren will sound for six 30 second cycles, then re-arm and ignore the opened door.
  • Page 5 2. If the LED is flashing two times...pause...two times...etc., then an intrusion attempt was made to the hood, trunk, or an optional sensor that has been connected to zone 2. 3. If the LED is flashing three times...pause...three times...etc., then an intrusion attempt was made through one of the vehicle's doors.
  • Page 6 2. Within 10 seconds of turning the ignition key off, press and release the LED valet push-button switch three times. 3a. If, before proceeding with step 2, the chirps were on, then you will hear 2 chirps to indicate that the chirps have been turned off. 3b.
  • Page 7 PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1) Transmitter Model Name, 143BP Is Also Found On Back Of Transmitter Case (Battery Use CR2032) 1) Turn the ignition key to the on position. 2) Press and release the valet/programming switch 3 times (Siren Chirps) 3) Press the Lock Button of each transmitter you want programmed until you hear a chirp from the horn or siren.
  • Page 8 APS-25E SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING ..........PASSIVE ARMING SLOW FLASHING ..........ARMED OFF ..............DISARMED ON - SOLID ............VALET MODE 3 FLASH ... PAUSE ..........INTRUSION ZONE 3 2 FLASH ... PAUSE ..........INTRUSION ZONE 2 **1 FLASH ...

Table of Contents