Buttonhole Making - Kenmore 1020 Owner's Manual

BUTTONHOLE MAKING
SETTINGS
Stitch Width Control - 4
Stitch Length Control - Red Zone
Zigzag Presser Foot
Use zigzag stitching plate.
1. Carefully mark the position and
length of each buttonhole on your
garment. Select the proper size
buttonhole guide foot to corre-
spond with the length of button-
hole.
2, Mount the guide foot onto the
presser foot. Holding on to the
top thread, rotate the handwheel
toward you one complete turn.
Pull the upper thread under and
to the back of the buttonhole
guide foot. See Figs. 1 & 2.
3. Note in Fig. 3 that each guide
foot has a dot on the right ed;_
toward the back of the foot, and
on the left edge near the front of
the foot. These dots are used as a
point of reference for your bartack-
ing steps in buttonholing. (See
next page).
4. Slide the guide foot forward until
the rear edge of the presser foot
is at the rear edge of the guide.
5. Place the fabric with the marked
buttonhole under the guide foot.
Lower the presser foot lever and
follow steps on next page.
(Check Hints for Perfect Button-
holes on Page 32.)
\
Fig. 1
g. 2
Hinge
Fig. 3
3O