Crossfade Always Controls Pb1 - ChamSys MagicQ User Manual

ChamSys Ltd
The two faders can then be used to fade in each new Cue with separate control for fade in and fade out.
Pressing the Go button on either Playback 9 or 10 returns the current playback to normal Cue execution.
When enabled, playbacks faders 9 and 10 can not be used as normal playbacks.
19.11.5

Crossfade always controls PB1

This option enables the user to lock the manual playback section of MagicQ to Playback Fader 1
regardless of the currently selected Playback. This is designed for theatrical use where Playback Fader 1
always contains the master Cue Stack.
19.11.6 Stomp Playbacks
When the Playback Stomping
playbacks will be automatically released (stomped).
19.11.7 Intensity (HTP) FX can subtract
This option determines whether one Playback intensity level can subtract from another Playback's level.
When set to "yes" an FX on one Playback can subtract from the level on another Playback. When set to
"no" MagicQ performs pure HTP – i.e. the highest level (including FX) from all the Playbacks is output.
19.11.8 Go reasserts channels
This setting determines which channels are reasserted when the Go button of a Playback is pressed. The
options are "All inc tracked", "non tracked" and "All no fade".
When set to "All inc tracked", then pressing GO on the Playback will reassert channels that are tracking
through the Cue Stack even if they were being controlled by another Playback. When set to "non tracked"
only channels that are recorded as "hard values" in the current Cue will be reasserted.
"All no fade" forces an immediate change of the channel values controlled by the Playback.
19.11.9 Fader off zero reasserts channels
This setting is used to reassert channels using the fader. This setting is useful when using Cue Stacks with
the "Fader Releases" set to No and "Flash releases" set to No.
When set to Yes, faders reassert the Playback when the level leaves zero. The setting "Go reasserts
channels" specifies how the channels are reasserted.
19.11.10 Next Page changes to next used
This setting enables page changes using the Next Page and Prev Page buttons to only access programmed
pages rather than changing through all pages. Any page can be accessed through the Page Window.
19.11.11 Current Playback follows last touched
MagicQ User Manual
option is enabled, playbacks that have been fully overridden by other
177
www.chamsys.co.uk
Version 1.4.9.0