Troubleshooting; 10. Technical Specification - Whirlpool VB-100 Instruction Manual

9. Troubleshooting

WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner
before performing maintenance or troubleshooting checks.
PROBLEM:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
PROBLEM:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
PROBLEM:
Cause:
Solution:
PROBLEM:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:

10. Technical Specification

Model:
Voltage:
Power:
Capacity:
Cord length:
*
Subject to technical change without notice.
11. Service & Help
Please contact Whirlpool Service Centre:
Address : 14/F Wilson Logistics Centre, 24-28 Kung Yip Street, Kwai Chung, Hong Kong
Star Hotline : 852-2406 9138
Vacuum cleaner won't run
Not properly plugged into electrical outlet.
Plug in securely.
No electricity in the electrical outlet.
Check fuse or breaker.
On/off switch not turned on.
Push on/off switch to 'on'.
Blocked central filter.
Remove, clean and replace filters. See page 6.
Blown fuse/tripped breaker.
Reset circuit breaker or replace fuse.
Cleaner won't pick up/loss of suction.
Dirt container not installed properly.
Review dirt container replacement.
Dirt container full or blocked.
Empty dirt container.
Clogged filters.
Remove, clean and replace filters.
Accessories won't pick up.
Accessories are not attached correctly.
Refer to section 5.
Dust escaping from the vacuum cleaner
Dirt container full.
Empty dirt container.
Dirt container not installed correctly.
Review dirt container replacement.
Hose is not installed correctly.
Review installation.
Filter not installed completely.
Remove, clean and replace filters.
VB-100
220V ~50Hz
1400W
1.6 Litres approx
5M approx