NightWatcher NW520 User Manual

Motorised led flood light

Model #NW520

USER GUIDE

MOTORISED LED FLOOD LIGHT

CAN WE HELP?

Questions, problems, missing parts? Before returning to the store call

Nightwatcher Customer Service:

0845 900 6764

Or Email: support@nightwatchersecurity.co.uk

THANK YOU

We appreciate the trust and confidence you have placed in Nightwatcher through the purchase of this motorised LED flood light.

We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products

available for your home improvement needs. Thank you for choosing Nightwatcher!

Table of Contents

Need help?

Do you have a question about the NW520 and is the answer not in the manual?

Page 1 THANK YOU We appreciate the trust and confidence you have placed in Nightwatcher through the purchase of this motorised LED flood light. We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products...
Page 2: Installation Instructions
INSTALLATION INSTRUCTIONS Read all instructions before proceeding with the installation OVERVIEW OF NW520 Push-button Push-button IMPORTANT: THE INTALLATION OF THIS FITTING MUST BE DONE BY A QUALIFIED ELECTRICIAN.  This fitting must be earthed.  Do not mount the luminaire against inflammable surfaces.
Page 3 INSTALLATION AND WIRING INSTRUCTIONS Remove the inset back mounting box from the luminaire. Fit the inset back mounting box onto the wall and tighten the screws at a height that ensures adequate coverage of the area by the infrared detector. The minimum installation height is 2 meters. And the maximum height is 3 meters.
Page 4 - Stepper Motor : when the stepper motor is reaching the end of its life or is damaged, the bottom hidden LED will flash red to signal a malfunction. Please switch the NW520 off and on at the mains, the tracking light now may or may not resume operation.
Page 5 OPERATION 1. Turn on the wall switch to activate the light, the light is now under Night-time mode NOTE: Allow approximately 30 seconds warm-up time before the sensor resumes normal activity. 2. To test, walk through the sensor’s detection area. 3.