Kenmore 153.31242 Use And Care Manual page 21

2.
3.
4.
5.
6.
7.
Make sure the electrical supply to your water heater is
"ON".
Check for loose or blown fuses in your water heater
circuit.
Circuit breakers weaken with age and may not handle their
rated load and should be replaced.
Make certain the disconnect switch, if used, is in the "ON"
position.
Check to see the electric service to your house has not
been interrupted. If this is the case, contact the electric
company.
Is the thermostat set to the desired temperature? See
Temperature Regulation section.
If you had experienced very hot water and now no hot water,
the problem may be due to the high temperature shut off
system. See High Temperature Shut Off System in the
Troubleshooting section.
8.
9.
10.
During very cold weather, the incoming water will also be
colder and it will require a longer time to become heated.
The hot water usage may exceed the capacity of the water
heater. If so, wait for water heater to recover after abnormal
demand. Also examine pipes and faucets for possible water
leaks.
If you can not determine the problem, then call the Sears
Service Department.
WATER IS TOO HOT
Adjust the thermostat to a lower setting. See the Temperature
Regulation section.
21