Download Print this page
Kenmore 72785 Installation, Care & Use Manual
Kenmore 72785 Installation, Care & Use Manual

Kenmore 72785 Installation, Care & Use Manual

Kenmore garbage disposal user manual

Advertisement

Quick Links

-m
®
FOOD WASTE DISPOSERS
installation,
Care & Use Manual
TOOLS AND MATERIALS
YOU WILL NEED:
Slotted
Screwdriver,
Adjustable
Pliers,
Plumber's
Putty,
Electrical
Tape
TOOLS,
MATERIALS,
AND ACCESSORIES
YOU MAY NEED:
Phillips
Screwdriver,
Drain Auger,
3/8" Electrical
Clamp
Connector,
Wire Nuts (2), Second
1 1/2" Drain Trap,
Hammer,
Hacksaw,
Water
Hose Clamp,
Pipe Wrench,
Copper
Ground
Wire, Dishwasher
Drain Connection
Kit, Air
Gap, Electrical
On/Off
Switch,
Drain Tube Extension
Read through
the entire
Installation,
Care
& Use manual
before
installing
the dis-
poser.
Determine
which
of the tools,
materials,
and accessories
you will need
before
you
begin.
Make sure you
have all
necessary
disposer
parts
before
install-
ing the disposer
(see part identification
diagram
below).
(_)1&
Otc
Mounting
Assembly
A Stopper
B Sink
Flange
C F_ber Gasket
D. Backup
Rmg
E. Mounting
Ring
F Screws
(3)
G Snap Ring
d
K
#1
OR
#2
00
N
Disposer
H Mounting
Gasket/Splash
Baffle
I
Lower
Mounting
Ring
J
D_shwasher
Inlet
K D_scharge
Outlet
L' Wrenchette
#1
OR
#2
Discharge
Assembly
#1
M Nut
N. Beveled
DLscharge Tube
(1-1/2" Dlam )
O. Beveled
Washer
P. Flanged
Gasket
--
Discharge
Assembly
#2
M. Bolt
N. Discharge
Tube (1-1/2"
Diarn )
O Flange
P Gasket
SAFETY
SYMBOLS
Danger indicates an
imminently hazardous situation which,
if not avoided, wdl result m death or
senous injury
I'_k WARNING I Warning indicates
a potentrally hazardous s_tuation
which, if not avoided, could result m
death or serious injury
[',_gCAUTIONI
Caution indicates a
potentially hazardous situation which,
if not avoided, may result m minor or
moderate mjury
1
72785

Advertisement

loading

Summary of Contents for Kenmore 72785

  • Page 1 (1-1/2" Dlam ) O. Beveled Washer P. Flanged Gasket Discharge Assembly M. Bolt N. Discharge Tube (1-1/2" Diarn ) O Flange P Gasket [',_gCAUTIONI Caution indicates a potentially hazardous situation which, if not avoided, may result m minor or moderate mjury 72785...
  • Page 2: Check Installation

    CHECK INSTALLATION A. Disposer Height B. Distance from bottom of sink bowl to centerline of discharge outlet. (Add 1/2" when stainless steel sink is used.) C: Distance from centerline of the discharge outlet to end of discharge tube. D: D_sposer Width E: Distance from disposer vertical centerline to centerline of P-trap connection.
  • Page 3 REMOVE EXISTING DISPOSER 1. Turn off electrical power at fuse box or circuit breaker. Electric o Turn off electrical power at fuse box or circuit breaker before removing electrical cover plate, WARNING Personal o Do not position your head or body under disposer; unit could fall dunng removal or installatton.
  • Page 4 This disposer must be properly grounded. There are two ways to connect electrical 1.) Direct wire 2.) Plug in cord - installed at factory, or from Kenmore Kit #60686 (for all models listed in this manual) Disposer Circuit Requirements...
  • Page 5 CONNECT DISPOSER Clear any objects from inside the disposer grind chamber before mounting the disposer. ,&WARNING Personal Injury: Do not position unit could fall during installation. Posit;on disposer with three mounting tabs (A) ahgned in position to slide over mounting tracks (B) (see Figure 10-1).
  • Page 6 CONNECT D ISHWASHER DRAIN (IFAPPLICABLE) Connect thedishwasher tothe disposer through a nairgap(A). (Most dish- washer manufacturers recommend thatthe discharge water r uns through ana_r g aptoprevent backflow a nd/or dishwasher contaminatton.) knockout plug Ls removed (see Instruction 1).Plumbing connections comply w ithlocal p lumbing codes. o Ifyouhave a 7/8"diameter d_shwasher attach t hedrain hose tothedishwasher inlet.
  • Page 7 CONTINUOUS FEED DISPOSERS 1. Remove stopper from sink opening a ndrunstrong f lowofcoldwater. 2. Turn onwall s witch t ostart d isposer. 3. Slowly i nsert f ood waste intodisposer and position s topper tominimize possible ejection o f material while grinding (seeFigure A ). 4.
  • Page 8 KENMORE FOOD WASTE Model 6010 OneYear Model 6011 One Year Full Warranty Model 6012 One Year Full Warranty Model 6013 OneYear For the duration of the warranty repair or replace, free of charge, appear in this disposer. WARRANTY SERVICE NEAREST SEARS STATES.

This manual is also suitable for:

6056 - 3/4 hp batch feed food waste disposer601060126011601360552 ... Show all