Advertisement
Quick Links
Advertisement
Summary of Contents for NorthStar 190 BATH/SPA TV
- Page 1 NORTHSTAR™ 190 BATH/SPA TV Installation Instructions...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Must be installed by a qualified electrician Read these instructions. Keep these instructions for future use. Install in accordance with manufacturer’s instructions. This product is suitable for wet locations. Clean only with water, mild soap and soft cloth. Do not clean with harsh detergents. -
Page 3: Installation
The 12V side of the AC/DC adapter powers the Northstar LCD-TV. The AC/DC adapter to the LCD-TV is fitted with a 25’ low voltage cable that should be fed behind the wall to the LCD-TV. Make sure there are two (2) feet of extra slack at the LCD-TV to allow the power connector to be plugged into the TV for installation. -
Page 4: Installing The Mounting Bracket
INSTALLING THE LCD-TV Remove the Northstar 190 LCD-TV from its packaging. The back of the TV has a cable outlet module with cables configured to the customer’s requirements. In the proper orientation the cables exit downward out of the module. - Page 5 Test the LCD-TV Prior to sealing the unit, turn on the LCD TV and make sure it is operating properly. Seal the LCD-TV When you are sure that the unit is installed and operating correctly, turn the TV off and apply a clear non- corrosive* silicone sealant to the joint between the edges of the stainless steel bezel and the wall surface material.
- Page 6 BOSE™ SPEAKER INSTALLATION If using the ceiling Bose™ FreeSpace®ceiling mount options: Select Rough-In Pan location on the ceiling. See below for installation steps. If using the Bose™ wall mount options: Mark the location of the bracket plate on the wall. See below for installation steps. The following steps explain how to install the Mirror TV speaker on the ceiling/wall.
- Page 7 4. Insert the Bose™ speaker through circular cut out. 5. Connect the RCA cable to the speaker terminal. The live wire (black) is connected to the positive terminal and the neutral wire (white) is wired to the negative terminal. Connect the RCA cable to the speaker source on the 4 port wall plate.
- Page 8 7. Secure the speaker by tightening all screws. The screws will pull the speaker lock-down and secure the speaker in place. CONDUIT WITHOUT PLENUM COVER 1. Install the Bose™ 8/32 junction box onto the metal pan. Connect the conduit with RCA cable inside, to 4-port wall plate.
- Page 9 3. Place sheet rock underneath the pan and screw it onto the wood. 4. Cut a circular hole out of the sheet rock to match the circular hole in the metal pan. 5. Insert the Bose™ speaker through the circular cut out. THERE’S ONLY ONE™...
- Page 10 6. Connect the wire from the junction box cable (covered with conduit) to the speaker terminal. The live wire (black) is connected to the positive terminal and the neutral wire (white) is wired to the negative terminal. Screw the security bracket onto the back of the speaker. 7.
- Page 11 7. Secure the speaker by tightening all screws. The screws will pull the speaker lock-down and secure the speaker in place. INSERTING SPEAKER COVER 1. The speaker cover can be installed straight to the speaker if the sheet rock ceiling/wall does not need any additional painting.