Download Print this page

Kenmore 114.85925 Owner's Manual page 16

All surface floor cleaner

Advertisement

Review this table to find do-it-yourself solutions for minor performance problems. Any
service needed, other than maintenance described in this Owner's Manual, should be
performed by a Sears or other qualified service agent.
WARNING
Disconnect
electrical
supply before
performing
maintenance
to the unit.
Failure
to do so could result in electrical
shock or personal
injury.
All Surface
Floor
Cleaner
won't
run
t.
2.
3.
4.
5.
All Surface
Floor
1.
Cleaner
won't
2.
pick up or low
suction
3.
4.
5.
6.
Water escaping
1.
from All Surface
2.
Floor Cleaner
3.
All Surface
Floor
1.
Cleaner won't
dispense
solution
2,
3.
Brushroll
not
1.
rotating
2.
3.
Power cord not firmly plugged
into outlet.
Blown fuse or tripped breaker.
Brush clogged.
Thermal Protector activated.
Needs service.
Incorrectly assembled.
Clean/Dirty Water Tank not
installed properly.
Dirty water tank is full.
Nozzle clogged
Filter clogged or dirty.
Incorrect nozzle attached.
Dirty Water Tank Is full.
Clean/Dirty Water Tank not
installed properly.
Solution trigger pulled.
Clean/Dirty Water Tank not
installed properly.
Clean Water Tank empty.
Solution trigger not pulled
Brush On/Off switch not in
ON position
Brushrolt clogged
Belt broken
1. Plugunit in firmly.
2.
Check fuse or breaker in home. Replace
fuse/reset
breaker.
3.
Unplug unit. Remove debris from brushro]l
and push brushron reset button.
4.
Unplug All Surface Floor Cleaner. Allow to
cool for 30 minutes before use.
5.
Take to Sears Service Center.
1.
Reassemble All Surface Floor Cleaner.
2,
Secure tank - Pg. 13
3.
Empty Dirty Water Tank- Pg. 13
4.
Clean nozzle opening.
5.
Remove filter and clean - Pg. 14
6.
Attach correct nozzle (tangerine for hard
floors, green for carpets) - Pg. 10-11
1.
Empty Dirty Water Tank- Pg. t3
2.
Secure Tank- Pg. 13
3.
Release solution trigger.
1,
Secure Tank.
2,
Fill Clean Water Tank.
3.
Pull solution trigger.
1.
Move Brush On/Off switch to ON position.
2. Unplugunit. Remove debris from brushroll
and push brushrollreset button.
3. Take to Sears Service Center.
16

Advertisement

loading