Install The Door Handle; Custom Panel Dimensions - IKEA W10282555A Installation Instructions Manual

Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed
(you will need to measure the lowest point on the
underside of the countertop and the highest point on the
floor). Refer to "Dishwasher Height Adjustment Chart"
for wheel position and the number of turns needed.
Dishwasher Height Adjustment Chart
Cabinet Wheel
opening height position
Removed
34" (86.4 cm)
(87.0 cm)
NOTE: If the minimum cabinet opening height is less than
34" (86.4 cm), the rear wheels can be removed for
additional clearance. This will allow the dishwasher to fit
into a 33⁷⁄₈" (86 cm) high cabinet opening, but the
dishwasher will be more difficult to move. (Measurements
are approximate. Wheels and legs are preset at the
factory for 34¹⁄₂" [87.6 cm].)
2 Adjust wheels and legs
Turn both leveler legs to the same height. Put wheels in
the required position determined from "Dishwasher
Height Adjustment Chart."
3
Built-up Floors—Add
shims as needed
2
"
( 5
c m
)
Built-up floors: If the kitchen floor is higher than the
cabinet opening's floor - for example, the kitchen floor tile
does not extend into the cabinet opening - add shims as
needed in the area shown to bring the dishwasher up to
34 " (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to avoid
movement when the dishwasher is in use.
14
Number of turns
on front leg
All the way up
1 10
2 5
3 0
wheel

Install the Door Handle

(on some models)
Install door handle
Mounting
stud
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware bag containing the
setscrews and hex key from the cardboard box. Setscrews
are already installed in the handle. Place handle on
mounting studs with the setscrews facing down. Push the
door handle tightly against the door. Insert the short end of
the hex key into the setscrews. Tighten the setscrews ¹⁄₄
turn past snug.
Retain hex key with Installation Instructions.

Custom Panel Dimensions

IMPORTANT: You need to know which control panel is on
your dishwasher before you order your custom door
panel.
1
2
Custom panel dimensions—Dishwashers
3
with control panel on the top
(59.7 cm)
* * This dimension is for 4" (10.2 cm) toe kick. If the
installation needs a higher toe kick, adjust the height
of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
Setscrew
(in bottom
of handle)
Handle
Mounting
stud
Hex key
³⁄₄" (19.1 mm)