Table of Contents
Advertisement
3.3.1 HDD Installation for cPCI-6765(A)
Find the HDD accessory pack inside your original package. (Users
purchasing the OEM model, non-standard, customized or special
configuration model, the HDD accessory package may not be included as
part of the packaging. Please contact ADLINK dealers or sales
representatives to purchase this accessory pack).
1.
Check the master/slave setting of your 2.5" ATA HDD
2.
Screw on 4 stand-offs to the HDD on the component side where there a
4 mounting holes available. See figure 3 b elow.
Figure 3: Mounting Location of stand-off on 2.5" HDD
3.
Align the 4 stand-offs attached to the HDD to the 4 mounting holes on the
board. Note the HDD is mounted on the component side of the board
and its IDE connector is facing away from the front panel.
4.
Using M3x5 screws, fix the HDD to the board by screwing from the
bottom side of the board.
5.
Connect the 44-pin HDD cable (44-pin), check if pin #1 of the IDE
connector, cable and the HDD are matched.
Getting Started • 37
Advertisement
Table of Contents
Need help?
Do you have a question about the cPCI-6765 and is the answer not in the manual?
Questions and answers