Adding Pedals; Adding Mudguards; Front Mudguard; Rear Mudguard - Frog Bikes Bike User Manual

f) Adding pedals
The pedals are pre-greased and marked Right and Left.
» Insert the Right pedal into the right crank arm
(on the chain side) and turn clockwise to fit
» Insert the Left pedal into the left crank arm and turn
anticlockwise to fit
» No force is required - screw the pedals in with your fingers and
then tighten using a size 15 spanner. Avoid over tightening
Note: If you are moving up from a balance bike, it is a good idea to let your
child get used to their bigger bike without using the pedals. Only add pedals
when your child is ready to use them and when they are confident riding the
new bike without them.
g) Adding Mudguards
There are front and rear mudguards to protect the rider from splashes.
There are 2 mudguards.

Front Mudguard:

» Put the largest bolt through the hole at the top of the forks, using
the rubber washer to protect the paintwork. Attach the front
mudguard using this bolt and secure it with a nut and washer

Rear Mudguard:

» Put both the smaller bolts through the rear mudguard
and mudguard clamp as shown, engaging the 2
nuts in the recesses on the left hand side.
frogbikes.com
» Remove the saddle and seat post from the bike. Slide the seat post
through the clamp and tighten the front bolt at the right height.
Replace the seat post on the frame. Re-tighten both bolts
» Replace the seat post.
Frog Bikes
Manual
Issue 3
September 2013