In The Box; Fitting The Front Wheel - Frog Bikes Bike User Manual

In the box you will find
» 1 bike with front wheel off
» 1 front wheel
» 1 bag containing 2 mudguards, 2 long bolts, 2 short bolts, 3 nuts, 1
curved plastic washer, 1 metal washer, 1 black mudguard clamp
» 1 box containing reflectors, pedals, front wheel Quando
skewer, allen key, warranty card and manual
Before you start, carefully remove all plastic wrapping, cable ties and
cardboard wraps.
a) Fitting the Front Wheel
» Remove the black plastic supporting rod from between the forks
» The front brake arms will need to be disconnected to get the front
wheel on. To do this, squeeze the left and right brake arms (or
"calipers") together and then slide the cable out of the cut-out piece
For the Tadpole, Frog 43 and Frog 48, place the front wheel axle in
between the jaws of the forks. Keep the safety washers on the outside of
each fork, and plug them into the holes.
frogbikes.com
» Use a 15mm spanner to tighten the nuts
For all others sizes of bike:
» Find the Quando skewer which is in the box with the pedals and
reflectors, unscrew the plastic nut off the end and place the skewer
through the wheel. Make sure that there is a spring either side of the
wheel; the widest part of each spring should be furthest away from
the wheel. The quick release handle goes on the left side of the bike,
and the "Drive —›" marking on the tyre should be pointing forwards
» Open the quick-release lever on the front wheel
» Insert the wheel into the jaws of the front forks (these look
like open jaws), keeping the quick-release lever on the left
» Tighten up the nut on the opposite side to the quick-release
lever and then close the lever with a firm pressure. If it is too
tight to close, release the nut a little then try to close it again
Frog Bikes
Manual
Issue 3
September 2013