Advertisement
Advertisement
Table of Contents
Related Manuals for SIB Standalone Keypad Access Control
Summary of Contents for SIB Standalone Keypad Access Control
-
Page 1: User Manual
Standalone Keypad Access Control User Manual... -
Page 2: Packing List
Please read the manual carefully before use this unit 1. Packing List Name Quantity Remarks Keypad User manual Φ20mm×60mm,Special for keypad Screw driver Φ6mm×30 mm Rubber plug , used for fixing Φ4mm×28 mm Self tapping screws , used for fixing Φ3mm×6mm, used for fixing Star screws... - Page 3 To unlock the door for a card user Present the card 3. Description The unit is single door multifunction standalone access controller or a Wiegand output keypad or card reader. It is suitable for mounting either indoor or outdoor in harsh environments.
-
Page 4: Specifications
5. Specifications Operating Voltage 9-28V DC User Capacity 2000 Card Reading Distance 3-6 cm ＜60mA Active Current Idle Current 25±5 mA Lock Output Load Max 3A Alarm Output Load Max 20A Operating Temperature -45℃～60℃ Operating Humidity 10%- 90% RH Waterproof Conforms to IP68 Adjustable Door Relay time 0 -99 seconds... -
Page 5: To Reset To Factory Default
7. Wiring Colour Function Description Pink BELL_A Doorbell button one end Pale blue BELL_B Doorbell button to the other end Green WG output D0 White WG output D1 Grey ALARM Alarm negative(alarm positive connected 12 V+) Yellow OPEN Exit button one end(the other end connected GND) Brown D_IN Magnetic switch one end(the other end connected GND) -
Page 6: Anti Tamper Alarm
9. Anti Tamper Alarm The unit uses a LDR (light dependent resistor) as an anti tamper alarm. If the keypad is removed from the cover then the tamper alarm will operate. 10.Sound and Light indication Operation Status Red Light Green Light Yellow Light Buzzer Power on... - Page 7 The ID number is any number between 1 & 2000. The PIN is any four digits between 0000 & 9999 with the exception of 1234 which is reserved. Users can be added continuously without exiting programming mode as follows: User ID no 1 # PIN # User ID no 2 # PIN # To delete a PIN user...
- Page 8 To delete a card user by card number. Card number This option can be used when the user Note users can be deleted continuously without want to make the change but the card exiting programming mode has lost To add a card and PIN user in card and PIN mode (3 To Add a card and Pin user Add the card as for a card user (The PIN is any four digits between 0000...
- Page 9 11.2 Door Settings Relay Output Delay Time To set door relay strike time Master code # 0～99 0-99 is to set the door relay time 0-99 seconds Door Open Detection Door Open Too Long (DOTL) warning. When used with an optional magnetic contact or built-in magnetic contact of the lock, if the door is opened normally, but not closed after 1 minute, the inside buzzer will beep automatically to remind people to close the door and continue for 1 minute before switching off automatically.
Need help?
Do you have a question about the Standalone Keypad Access Control and is the answer not in the manual?
Questions and answers