Explanatory Table For Operation Display - Gazelle Easy Glider User Manual

13. Explanatory table for operation display

Description/error LED
"Battery full"
"Battery half full"
Directly after turning ON
"Battery low"
"Boost"
"Normal"
"Eco"
Battery voltage low
"Battery low"
(less than 10% capacity)
Battery low
"Battery low"
(0% for assistance)
"Battery full"
Zero setting error
"Battery half full"
for torque measurement
"Battery low"
by torque sensor
"Mode Boost"
"Mode Normal"
Go to your Gazelle dealer.
"Mode Eco"
"Battery full"
"Battery half full"
Motor error
"Battery low"
"Mode Boost"
"Mode Normal"
"Mode Eco"
Go to your Gazelle dealer.
Overheating "Selected Mode"
More intense "Selected Mode"
overheating
"Battery full"
Communication errors
"Battery half full"
"Battery low"
Torque measurement error: directly after switching ON you shouldn't apply any force to the pedal during 1 second,
because it takes 1 second to perform the torque measurement.
24
LED Light Status
(0.5 seconds / block)
Shows remaining battery capacity
Zero setting display for 1 second.
Start in "Normal" mode.
(continue)
No pedal assistance.
(continue)
No pedal assistance, but the sensor can be reset by
(continue)
pressing the Power button twice (O & On).
Go to your Gazelle dealer if this doesn't x the
malfunction.
(continue)
No pedal assistance and no resetting possible.
Motor must be replaced. Go to your Gazelle dealer.
Restore by cooling down
Lower the maximum motor load.
Lower the maximum motor load further than in the
Restore by cooling down
above case.
If the battery capacity falls below 10%,
(continue)
the "battery low" LED will blink.
Remarks
25