Troubleshooting - Game ready 550550 User Manual

t r o U B l e S H o o t i n G
WHAt doeS
error
it MeAn?
Air pressure Sensor: The
Control Unit has detected
a problem calibrating the
pneumatic compression circuit
on start-up.
Self-test error – Air pump:
The Control Unit has detected
an electronic problem in the air
circuit on start-up.
dry pump: The Control Unit has
detected a dry pump. In order
to prevent possible damage to
the fluid pump, the unit will stop
therapy.
over pressure: indicates that
the Control Unit has exceeded
the target pressure.
WHAt CAn
i do?
• This is most likely to occur if you
have restarted the System with an
inflated Wrap attached.
• Detach the Wrap and try again.
• Disconnect the Wrap from the
Control Unit.
• Turn the Control Unit off and on
again without a Wrap connected.
• Make sure there is water in the ice
box.
• Verify that the ice box filter is not
clogged.
• Make sure there are no kinks in the
Wrap or Connector Hose.
• Turn the Control Unit off and on
again.
• Turn the temperature knob to full
cold until flow has been established.
• Disconnect and reconnect the hose
from the Control Unit and the Wrap.
• Prime the Wrap using the following
steps:
• Select "No Pressure."
• Attach the largest Wrap available.
• Lay the Wrap open (not on the
body).
• Run the System for 1 minute.
• Prime the System using the
following steps:
• Disconnect the hose from the
Control Unit.
• Now, look at the Wrap connection
location on the Control Unit. On the
top valve, push the white prong
in so that it is even with the metal
connector.
• Make sure you are not fully covering
the opening in the prong.
• Push start, and water should squirt
out of the valve.
• Restart the System.
• Turn the Control Unit off and back
on.
• Apply the same Wrap more tightly.
• Apply a different Wrap.
EN-17