Rear View - Pioneer DRM-6NX Service Manual

DRM-6NX

Rear View

Ventilators
O p e n i n g s a r e p r o v i d e d f o r
ventilation, to ensure reliable
operation and to protect it from
overheating. These openings must
not be blocked or covered.
Black cover
The SCSI ID switch of
the internal CD-ROM
changer is inside this
cover. Note that chang-
ing this ID setting may
cause a breakdown. Do
not remove this cover.
FUNCTION switches
U s e d t o s e t t h e
operation mode of the
internal CD-ROM
changer. Turn the
power off to the unit
before changing the
operating mode.
No. 1: SCSI terminator switch for internal CD-
ROM changer
It is set to ON (terminator ON) at time of shipment.
Set it to OFF (terminator OFF) when other drives are
to be connected to the SCSI terminal and set the
terminator on the connected drive.
No. 2: RESERVE (for service use only)
Must be set to OFF.
No. 3: Disable magazine eject button
ON: Disables MAGAZIN EJECT button (eject disable)
OFF: Enables MAGAZIN EJECT button (eject enabled)
58
SCSI connector
A 50-pin Centronics connector for connecting external
PIONEER CD/DVD-ROM drives (a total of 5 units can be
connected)
NOTE:
÷ Do not connect a CD-ROM or DVD-ROM drive other than a Pioneer
drive to the SCSI terminal on the rear panel.
÷ Do not connect this terminal to a SCSI terminal on a PC as this could
cause malfunction or breakdown.
"SCSI CONNECTION FOR PIONEER CD-ROM/DVD-ROM DRIVE
ONLY. DO NOT CONNECTSCSI CONTROLLER."
÷ Assign a SCSI ID between 2 to 6 for drives that are connected. SCSI ID
0, 1 and 7 are reserved for the internal CD-ROM changer, hard disk drive
and network board. Thus never assign IDs 0, 1 or 7 to an external drive.
AC IN socket
Connect to a wall outlet. This unit is designed to operate at AC
110 – 240 V 50/60 Hz. (There is no power supply voltage
swtich because switchover takes place automatically inside
the unit.)
The accessory power cable is for use in North America.
In order regions, please consult your dealer for imformation on
how to purchase a power cable.
Reset button
Press this button to return all settings to their factory defaults.
Network connector
Connect to the Ethernet or Token Ring network (RJ-45
connector, 100 Base-TX/10 Base-T).
SIGNAL GND
terminal