Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Black & Decker 500AMPJUMP-STARTER WITHINFLATOR
Summary of Contents for Black & Decker 500AMPJUMP-STARTER WITHINFLATOR
-
Page 1: Instruction Manual
500 AMP JUMP-STARTER WITH INFLATOR INSTRUCTION MANUAL Catalog Number JUS500IB... -
Page 2: Safety Guidelines - Definitions
• EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage SAFETY GUIDELINES / DEFINITIONS resulting in loss of power and overheating. - Page 3 • If battery acid contacts skin or clothing, wash immediately with soap and water for at least 10 minutes and get This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device medical attention immediately.
-
Page 4: Jump-Starter
Controls and Indicators Note: This unit is delivered in a partially charged state – you must fully charge it before using it for the first time. Initial AC charge should be for 24 hours. Charging/Recharging Using the 120 Volt AC Charger and a Standard Household Extension Cord (not included) 1.Lift the AC adapter cover located on the front of the unit and connect an extension cord to the unit. -
Page 5: Troubleshooting
LED AREA LIGHT Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire). The area light is controlled by the Area Light Power Switch on the front panel of the unit. Make sure the lamp is turned OFF when the unit is being recharged or stored.
Need help?
Do you have a question about the 500AMPJUMP-STARTER WITHINFLATOR and is the answer not in the manual?
Questions and answers