Advertisement
Quick Links
Components
A
1 x Heater
C
1 x Top Plate
Fittings
A
4 x Screw
B
Homebase Ltd.
Avebury, Milton Keynes, MK 9 2NW.
B
1 x Top Wire Frame
E
1 x Middle Wire Frame
D
1 x Base
F
1 x Quick Connector
3 x Nut
C
3 x Spacer Screw
For further information contact
Customer Service: 0845 0778888
www.homebase.co.uk.
Table Top Patio Heater
Simple Assembly Instructions
IMPORTANT
1. Read these instructions carefully and
familiarise yourself with the procedure
before assembling the unit.
2. Check that you have all the component
parts following the list on the back
cover and familiarise yourself with
each part before proceeding.
-
Please keep for future reference
3. Take all the fittings out of the plastic bag
and separate them into their groups.
4. Ensure you have enough space to lay out
all the parts before assembly.
5. To avoid scratching it is recommended
that you assemble the unit on a soft
level surface.
PTG018S
Advertisement
Summary of Contents for Home Base PTG018S
- Page 1 5. To avoid scratching it is recommended cover and familiarise yourself with that you assemble the unit on a soft each part before proceeding. level surface. Homebase Ltd. For further information contact PTG018S Avebury, Milton Keynes, MK 9 2NW. Customer Service: 0845 0778888 www.homebase.co.uk.
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS "Read all instruction before use" and keep for future reference. Please follow carefully all assembly instructions in this manual. Failure to do so could result in serious harm. NOTE • This appliance must be installed and the gas cylinder stored in accordance with the regulations in your area. - Page 3 Assembly Instructions Assembly Instructions Stage 1 – Stage 2 – Fitting the Base Fitting the Top Plate IMPORTANT: 1. Carefully fit the Middle Wire Frame E using the hooks to locate into Please read the important safety the Heater Frame. instructions before use.
- Page 4 Assembly Instructions Assembly Instructions Stage 3 – Stage 4 – Operating the Quick Connector Preparation Connect the Quick Connector F CAUTION: 1. Slide the collar of Quick Connector Please read the important safety F back and insert the other end of instructions before use.
- Page 5 Assembly Instructions Assembly Instructions Stage 4 – Stage 4 – Preparation Preparation Gas bottle connection Type of Regulator to be used: How to connect the gas bottle: • Low pressure L.P. Gas Regulator. 1. Check that the control knob and •...
-
Page 6: Specifications
Technical Information 1. Turn the Control Knob clockwise to "OFF" position. Homebase MK9 2NW See fig. 11. Model no. PTG018S Total Heat Output: 4.5 kW Gas Consumption: 327 g/h 2. Turn the gas supply "ON" at the cylinder regulator. Gas Category: 3+(28-30/37) 3.
Need help?
Do you have a question about the PTG018S and is the answer not in the manual?
Questions and answers