On Wan; Remote Surveillance Through Apple Pc - Provision ISR NVR-16400(1U) User Manual

and 123456.

8.1.2 On WAN

There are two ways for the NVR to connect to internet.
1. Connect the NVR to internet through router or virtual server
Step 1: Enter into the NVR's Main MenuSetupNetwork interface to input IP address,
Subnet Mask, etc. If using DHCP, please enable DHCP in both the NVR and router.
Step 2: Forward IP address and port number in Virtual Server setup of the router or virtual
server. Configure the firewall to allow accessing the NVR.
Note: Port forwarding settings may be different in different routers and server. Please refer to the router's
manual for details.
Step 3: Open IE browser, input IP address, or dynamic domain name and enter. If HTTP port is
not 80, add the port number after IP address or domain name.
Step 4: IE will download ActiveX control automatically. Then a window pops up and asks for
user name and password. Input name and password correctly, and enter to view.
Note: If you cannot download and install ActiveX control, please refer to FAQ Q8.
2. Connect the NVR to internet through PPPoE directly.
Step 1: Enter into the NVR's Main MenuSetupNetwork interface to enable PPPoE and
then input user name and password received from your ISP. Next, click 'Apply'. The NVR will
connect to the server and would give a confirmation message.
Step 2: When accessing the remote interface of NVR, user can input WAN IP to access directly
(user can enter into Main menuInformationNetwork interface to check IP address).
Step 3: If users want to utilize dynamic domain name, please apply for a domain name in a
DNS server supported by the NVR or router. Then add to the NVR.
Step 4: Open IE browser to input WAN IP address or domain name and then enter. If HTTP
port is not 80, add the port number after IP address or domain name.

8.2 Remote Surveillance through Apple PC

Note: Because the current plug-in version of client end just only supports 32-bit mode, so the safari
browser shall start 32-bit mode. If the browser is the earlier MACOS version, the default setting is 32-bit
mode and the setting can be skipped.
The Setting steps are as follows:
First: Right click safari icon and select "Show in Finder".
Second: Select ApplicationsRight click "Safari. App"Select "Get Info".