Installing Internal Hard Disk Drives; Figure 2-21 Front View Of The Hp 9000 Rp3410/Hp 9000 Rp3440 Server - HP 9000 rp3440 Installation Manual

Installing and Configuring

Installing Internal Hard Disk Drives

Installing Internal Hard Disk Drives
This section provides information about installing additional internal hard disk drives.
CAUTION A hot-plug device may require interaction with the operating system before the device can be
safely installed into the server. Verify that the operating system supports installing disk drives
while the operating system is running. If the operating system does not support this feature,
shut down the operating system before attempting this procedure. Failure to observe this
caution will result in system failure.
Figure 2-21 Front View of the HP 9000 rp3410/HP 9000 rp3440 Server
LVD HDD
LVD HDD
Two additional hard disk drives may be added to your HP server in slots 2 and 3. Always use low profile disk
drives (1.0" height) in your HP 9000 rp3410 and HP 9000 rp3440 servers.
To install a hard disk drive, perform the following steps:
Step 1. If you will be locking the hard drive in place, you must remove the cover to access the hard drive
lock. Proceed as follows:
a. If rack-mounted, slide the HP server out from the rack until it stops. (See "Extend the Server
from the Rack" on page 25.)
b. Remove the cover and bezel. (See "Removing and Replacing System Covers and Bezels" on
page 25.)
36
System Product
Label (pull-out)
LVD HDD 1
Control Panel DVD Drive
Chapter 2