Parkray Consort 7 Installation And Operating Instructions Manual
Multifuel cleanburn stove
Hide thumbs
Also See for Consort 7:
Table of Contents
Advertisement
C O N S O R T 7
C O N S O R T 7
C O N S O R T 7
C O N S O R T 7
M U L T I F U E L
M U L T I F U E L
M U L T I F U E L
M U L T I F U E L
C L E A N B U R N
C L E A N B U R N
C L E A N B U R N
C L E A N B U R N
Installation and Operating Instructions
An accredited competent person must carry out the installation of this appliance;
alternatively, your local Building Control Officer can approve the completed
installation, should a non-accredited engineer undertake the installation. It is an
offence, under UK law, not to comply with this advice. Please hand these
instructions to the stove user when the installation is complete. Leave the system
ready for operation and instruct the user in the correct use of the appliance and
operation of controls.
S T O V E
S T O V E
S T O V E
S T O V E
Advertisement
Table of Contents
Related Manuals for Parkray Consort 7
Summary of Contents for Parkray Consort 7
- Page 1 C O N S O R T 7 C O N S O R T 7 C O N S O R T 7 C O N S O R T 7 M U L T I F U E L M U L T I F U E L M U L T I F U E L M U L T I F U E L...
-
Page 2: Technical Specification
Consort 7 Technical Specification Stove Mass 111 kg Wood Total Efficiency 75.9 % Nominal Heat Output 5.5 KW Mean CO Emission (at 13% O2) 0.27 % Mean Flue Gas Temperature 265 °C Flue Gas Mass Flow 5.7 g/s Ancit Total Efficiency 67.3 %... -
Page 3: Important Warning
Assembly Instructions PLEASE READ THESE INSTRUCTIONS CAREFULLY It is important that your stove is correctly installed, as Parkray cannot accept responsibility for any fault arising through incorrect use or installation. Important Warning This stove must not be installed into a chimney that serves any other heating appliance. -
Page 4: Fire Bricks
Fire Bricks The Fire Bricks, in this appliance, are factory fitted. The following set of photos show the removal sequence that you will need to employ when servicing your Parkray stove. Side Bricks Remove all the Riddling Bars, Cam Bar and Catch Bar from the Stove. -
Page 5: Installation Instructions
Installation Instructions These instructions cover the basic principles to ensure satisfactory installation of the stove, although detail may need slight modification to suit particular local site conditions. In all cases the installation must comply with current Building Regulations, Local Authority Byelaws, European and national standards and other specifications or regulations as they affect the installation of the stove. -
Page 6: Installation
Installation Chimney The chimney height and the position of the chimney terminal should conform to Building Regulations. Check that the chimney is in good condition, dry, free from cracks and obstructions. The diameter of the flue should not be less than 150mm and not more than 230mm. If any of these requirements are not met, the chimney should be lined by a suitable method. -
Page 7: Material Clearances
Material Clearances The stove can be recessed in a suitable sized fireplace but a permanent free air gap of at least 150mm must be left around the sides and top and at least 50mm at the back of the stove to obtain maximum heat output and for access to the rear of the stove. -
Page 8: Commissioning And Handover
Commissioning and Handover Upon completion of the installation, allow a suitable period of time for any fire cement and mortar to dry out. A small fire may then be lit and checked to ensure the smoke and fumes are taken from the stove up the chimney and emitted safely to atmosphere. -
Page 9: Operating Instructions
Operating Instructions This appliance is not suitable for use in a shared flue This appliance should not be operated with the doors open Aerosol Sprays Do not use an aerosol spray on or near the stove when it is alight. Air Controls This stove has been designed to burn cleaner and more efficiently than a conventional wood burning stove. -
Page 10: Multifuel Grate
Multifuel Grate Your Parkray stove is fitted with a locomotive type grate. So that de-ashing can be carried out cleanly and easily, it is riddled from the outside of the stove with the doors closed. The grate is designed to burn both wood and solid fuels. -
Page 11: Lighting The Stove
Lighting the Stove We recommend that you have two or three small fires before you operate your stove to its maximum heat output. This is to allow the paint to cure in steadily and to give a long service life of the paint finish. During this curing in process you may notice an unpleasant smell. -
Page 12: Safety Notes For Your Guidance
Safety notes for your guidance FIRES CAN BE DANGEROUS – Always use a fireguard in the presence of children, the elderly or the infirm. The fireguard should be manufactured in accordance with BS 6539 – Fireguards for use with solid fuel appliances. DO NOT OVERFIRE –... -
Page 13: General Maintenance
Rope Check the rope around the door and glass. If rope is becoming detached, use Parkray rope glue to reattach it. If the rope is in a poor condition, a replacement rope kit may be ordered from the... -
Page 14: Chimney And Flue Ways
Chimney and Flue ways It is important that the chimney, flue ways and any connecting flue pipe are swept regularly. This means at least once a year for smokeless fuels and at least twice a year for wood and other fuels. -
Page 15: Stove Spares
STOVE SPARES Only Parkray authorised spares should be used with this stove. RIGHT HAND DOOR Right Hand Door (CH06/003) Door Glass (CH06/018) Glass Gasket Glass Clip (HHR08/046) (CH06/019) Glass Clip Screw (FSJM05008SS) Door Handle (CHC04/010) 8mm Flat Washer (FWFM08-17) Door Slider (CH05/033) - Page 16 STOVE BODY ASSEMBLY - PART SECTION - MULTIFUEL Flue Collar (CH08/030) Flue Cover (CH08/031) Baffle Brick Side Brick (HH06/065) (HH06/115) Turbo Bar (HH06/101) Side Plates Rear Brick – M/F (HH06/121 A/B) (HH06/110) Riddling Support (HH06/022) Ashpan (HH06/025) Riddling Bar – Lower (CNS04/012) Riddling Bar –...
Need help?
Do you have a question about the Consort 7 and is the answer not in the manual?
Questions and answers