Dell E1200i ExaScale Installation Manual page 25

Hide thumbs Also See for E1200i ExaScale:
Table of Contents

Advertisement

WARNING: Zur Vermeidung von Körperverletzung beim Anbringen oder Warten dieser Einheit in einem
Gestell müssen Sie besondere Vorkehrungen treffen, um sicherzustellen, daß das System stabil bleibt. Die
folgenden Richtlinien sollen zur Gewährleistung Ihrer Sicherheit dienen:
Wenn diese Einheit die einzige im Gestell ist, sollte sie unten im Gestell angebracht werden.
Bei Anbringung dieser Einheit in einem zum Teil gefüllten Gestell ist das Gestell von unten nach oben zu
laden, wobei das schwerste Bauteil unten im Gestell anzubringen ist.
Wird das Gestell mit Stabilisierungszubehör geliefert, sind zuerst die Stabilisatoren zu installieren, bevor
Sie die Einheit im Gestell anbringen oder sie warten.
NOTE: Dell Force10 recommends that you install and operate the E1200 system in a standard 19-inch or 23-
inch equipment rack.
Install the E1200 system after you secure the equipment rack shelf bar. Load the chassis in the lower half
of an empty rack to avoid a top-heavy rack
WARNING: Do not remove the Front shipping Cover during the initial installation process. The cover provides
front handles to assist in lifting and prevents damage to the internal framework and EMI seals.
Figure 5-2. Rack-Mounting the Chassis
To install the chassis into a prepared rack:
Step
Task
If you center- or rear-mount the chassis in a 19-inch rack, adjust the chassis rack-mounting brackets to the desired
1
position.
If you mount the chassis in a 23-inch rack, install the 23-inch adapter brackets.
2
Use a hand cart, pallet jack, or forklift to align the rack-mount holes with the equipment rack holes, situating the
3
chassis on top of the equipment rack shelf bar.
Insert rack-mounting screws in the holes that are not obscured by the metal chassis shipping cover. Tighten the
4
screws. See
Figure
Loosen and remove the screws that secure the chassis Front Shipping Cover and remove the cover.
5
Insert the remaining rack-mounting screws and tighten to secure the chassis in the rack.
6
(Figure
5-2.
5-2)
Installing the DC Chassis
25
|

Advertisement

Table of Contents
loading

Table of Contents