Removing and refitting the variable loading floor
Fig. 99 Boot: Fold up variable loading floor
Fig. 100 Boot: remove variable loading floor
First read and observe the introductory information and safety warn-
ings
on page 89.
The variable loading floor can be removed and reinstalled, if necessary.
Removing
›
Grasp the rear part of the floor by the handle, raise it slightly in the direction of
the arrow
» Fig. 99
and pull it out over the bumper in the direction of the
1
arrow
until it engages in the opening
2
›
Fold up the loading floor by moving it in the direction of the arrow
›
Press the safety buttons
» Fig. 100
A
Install
›
Fold up the floor and place it on the carrier rails.
» Fig.
100.
C
» Fig.
3
and remove the floor.
›
Push the floor forwards until it engages in the openings
rails
» Fig.
100.
›
Carefully press in the vicinity of the openings
place, if necessary press the safety buttons
WARNING
Ensure the variable loading floor is attached correctly during installation. If
this is not the case, there is a risk of injury for the occupants.
Fixing set
Fig. 101 Telescopic pole and tensioning strap
First read and observe the introductory information and safety warn-
ings
on page 89.
The fixing set can be used for dividing the boot or for securing the objects which
are being transported.
Telescopic pole
›
Insert the holders for the telescopic pole into the left and right openings of the
carrier rails.
›
Press the top part of the holder in the direction of the arrow
simultaneously push in the desired position in the direction of the arrow
›
Ensure that the holder is correctly locked in place.
99.
Tensioning strap
›
Insert the tensioning strap holders into the opening on the left or right carrier
rail.
›
Press the holder in the direction of the arrow
push in the desired position in the direction of the arrow
in the carrier
B
on the floor until it clicks into
C
.
A
» Fig. 101
and
1
.
2
» Fig. 101
and simultaneously
3
.
4
91
Seats and useful equipment
Need help?
Do you have a question about the Superb and is the answer not in the manual?
Questions and answers