Panasonic KX-TD500 Installation Manual page 199

Remote Access Procedure
Starting up the System Administration from a remote location can be done in one of the
following ways:
a)
DISA (Direct Inward System Access)
Dial "Remote FDN" after accessing the KX-TD500 system using DISA feature.
b)
DID (Direct Inward Dialling)
Programme DID feature so that the incoming telephone number is converted to "Remote
FDN."
c)
DIL 1:1
Assign "Remote FDN" as the destination of a CO line whose "Incoming Type" is set to
"DIL."
d)
Call Transfer to Remote Administration Resource
The call from a remote location can be made on any trunk into the system, and be
answered by an extension user. The call is then placed on hold and the Remote FDN of
the system dialled is received. The extension user transfers the call after receiving the
modem answer tone. The caller at a remote location will then hear the modem answer
tone and can proceed with sign-on.
Notes
• Be sure to install the software (attached to the modem) to your PC before executing the
remote administration using a modem.
Otherwise, remote access cannot be executed successfully.
• When 'Manual' is selected in "Dial Type" menu, please dial the desired telephone
number using an SLT connected with the modem in parallel.
• To execute the Remote Administration, an ERMT card (KX-TD50197) should be
installed in the system or an External Modem should be connected to the RS-232C Port
1.
Maintenance Console Guide
3.4 System Administration
199