Resetting The Printer; Restoring Factory Defaults - Lexmark E360d Service Manual

4513-420, -430
User attendance messages (Continued)
Message
Prog System Code
DO NOT POWER OFF
Ready
Remove Paper Standard Bin
Resetting Maint Cnt Valu
Resetting PC Cnt Value

Resetting the Printer

Res Reduced

Restoring Factory Defaults

Std Bin Full
Toner Low
Tray <x> Missing
USM
Waiting
2-8
Lexmark™ E360d, E360dn
Action
The printer is programming new system code. Wait for the message to
clear and the printer to reset.
Warning: Do not turn the printer off while this message is displayed.
Send a job to print.
The standard output bin is full.
The printer is resetting the counter that tracks wear on the fuser.
The printer is resetting the counter that tracks wear on the photoconductor.
Wait for the message to clear.
The printer is reducing the resolution of a page in the current job from 600
dots per inch (dpi) to 300 dpi to prevent a 38 Memory Full error. Res
Reduced remains on the display while the job prints.
Wait for the message to clear.
Note: When factory default settings are restored:
• All downloaded resources (fonts, macros, symbol sets) in the
printer memory are deleted.
• All menu settings return to the factory default except:
—
The Display Language setting in the Setup Menu
—
All settings in the Parallel Menu, Network Menu, and
USB Menu
The standard bin is full.
• Replace the toner cartridge.
• Press to clear the message and continue printing.
Insert the tray into the printer.
The printer is processing data through the specified USB port.
The printer has received a page of data to print, but is waiting for an End of
Job command, a Form Feed command, or additional data.
• Press to print the contents of the buffer.
• Cancel the current job.