Summary of Contents for Corona Concepts Laurel
- Page 1 (56533) Corona Concepts presents The Laurel All Wood Dollhouse Instructions and Assembly Guides RTD10000575AA...
- Page 2 As pioneers in the early days of the die-cut dollhouse industry, the This kit was designed with designers for Corona Concepts have utilized a simpler method for building dollhouses. This kit has been designed with efficiency in effciency in mind.
-
Page 3: Before You Begin
(i.e., "front tabs" fit in piece labeled "front"). It is helpful to write in pencil, this information on the pieces before removing them from the sheets. All markings can easily be erased later. The Laurel Page 2... -
Page 4: Finishing Touches
Satin finish latex house paint will give a better result than either flat or gloss finish. Be sure to check your local craft shop for other decorative items such as siding, floor tiles, carpet, electrification kits, furniture, etc. The Laurel Page 3... -
Page 5: Assembly Instructions
(3). Butt and glue then two small risers flush to each end of the large riser. Position front step face down and glue riser assembly to it centered with back edges. Glue step assembly to front wall beneath door opening. Glue or hinge front door in place. The Laurel Page 4... - Page 6 You will notice one side is shorter than the other. The short end of the door trim will rest on the first tread of the staircase. Glue in place. On opposite sidewall The Laurel Page 5...
-
Page 7: Tools Required
5. Position front step assembly in a proper, centered spot off front porch and glue in place. Shingles, shingles, shingles... TOOLS REQUIRED Sharp Utility Knife Hot melt glue gun and glue Pencil and ruler or other straight edge The Laurel Page 6... -
Page 8: General Instructions
OPTIONAL 1" Foam Brush Wood Stain GENERAL INSTRUCTIONS 1. Carefully measure and draw parallel guidelines on the roof panels beginning at the bottom edge of the roof. Guidelines should be spaced apart no less than one half the length of one shingle. 2. - Page 9 Diagram #1 Diagram #2 © 2001 Corona Concepts 436 Lake Road Schenevus, NY 12155 www.corona-concepts.com All rights reserved...
Need help?
Do you have a question about the Laurel and is the answer not in the manual?
Questions and answers
Need part identifier sheet
The part identifier sheet for Corona Concepts Laurel uses numbers in parentheses, such as (8), to indicate the sheet number where a required piece can be located.
This answer is automatically generated