TWIG PROTECTOR Ex Quick Manual

TWIG PROTECTOR Ex
Intrinsically Safe and Rugged Protection Device (ATEX)

Quick Guide

TWIG Protector Ex protection device is
designed to be your personal "guardian
angel" – intended for all areas of personal
and professional safety in potentionally
explosive areas.
Instructed by simple icons, the device is
especially suitable for loneworkers as well
as for applications or situations where
simplicity and robustness is a must
Manufacturer:
Twig Com Oy,
24101 SALO, Finland
web: www.twigworld.com
0700 / 0537
Publication number: YZ3304-04
All rights reserved.
© Twig Com Plc
Twig Com Oy declares that this mobile device, type TGP81EG, is in
compliance with the essential requirements and other relevant provisions
of Directive 1999/5/.
Information in this Quick Guide is subject to change without notice. TWIG
COM reserves the right to change or improve their products and to make
changes in the content without obligation to notify any person or
organization of such changes or improvements. TWIG COM is not
responsible for any loss of data, income or any consequential damage
whatsoever caused.
Some of the features described in this guide are optional and intended to
be purchased separately. For more information, please contact your
dealer.
For more information, details and descriptions, including device
configuration and assortment of chargers and accessories, visit the web
site: www.twigworld.com.
WHAT TO DO FIRST
DOWNLOAD PC CONFIGURATION
INSTRUCTIONS AND USB
ftp://support.twigworld.com/public/
If possible turn off the PIN request from the SIM card. If not,
change the PIN code to 9999 or change the PIN code that is
programmed to Protector to same that is used in SIM card before
starting the phone. Changing the PIN code that unit automatically
uses, please refer to configuration guide and PC Configure
program.
INSERTING THE SIM CARD
silver tape in the salesbox to assist if you need to remove it or
inserting to SIM holder is difficult. Do not use force as the SIM
will go to its place easily.
2. Push the SIM card all the way in with e.g. another SIM card
or some small stick. Remove the tape if you used that pulling
sideways, so that SIM doesn't come out. Do not use sharp or
metal tools or objects!
3. Insert the rubber plug to the SIM holder hole.
4. Insert the seal tape carefully on top of the rubber plug.
C.f. ftp://support.twigworld.com/Public/Video_Instructions/
The device is dust and water proof. The protection
category for the device is IP67. To meet the requirements,
the rubber plug and the sealing tape must be inserted in
place correctly. If the seal or plus is damaged it must be
changed immediately to maintain tightness and warranty.
INITIALIZING THE DEVICE
When you start using the device for the first time, you should
charge the battery first. Please note that the battery will reach
its full capacity only after two or three charging times.
POWER SUPPLY
Device is equipped with system, that protects the unit for being
overloaded or malfunctioning causing danger to user. In rare
case where the device battery is overloaded. e.g heavy GPRS
transmission, the protection system turns the device off. Device
can be turned on again by connecting to charger. This must not
be done inside Ex area. This is normal behaviour. It is
suggested not to use GPRS to telematics to minimise the
SOFTWARE,
possible automatic turning off.
DRIVERS FROM
•Mains charger with the charger adapter or charging cradle
•Standard Li-Ion battery integrated to the unit is 1300mAh Li-po
battery. The battery type and capacity may vary depending on
the market area and model of the unit in the sales package.
1. Slide the SIM card
to the holder from the
hole on the side of
the unit slightly tilting
the SIM card towards
the keyboard when
MAINS CHARGER
pushing it in.
The mains charger should only be used indoors. Make sure that the
Contacts in the SIM
voltage in the country which you are staying corresponds to the
are facing towards
voltage marked on the charger. When charging, connect the mini USB
keypad and the cut
connector to mini USB connector in charging adapter or the charging
corner of the card
cradle. Twist the Charging adapter to the bottom of the phone from
outward. Use the
keyboardside down, all the way until it clicks on its place on back
cover.
If placing to charging adapter, place first the bottom towards the
charging pins in the cradle and the let the top of the unit lie down.
MAINS CHARGER
The mains charger should only be used indoors. Make sure that the
voltage in the country which you are staying corresponds to the
voltage marked on the charger. When charging, connect the mini USB
connector to mini USB connector in charging adapter or the charging
cradle. Twist the Charging adapter to the bottom of the phone from
keyboardside down, all the way until it clicks on its place on back
cover. Charge minimum 3 hours after use.
If placing to charging adapter, place first the bottom towards the
charging pins in the cradle and the let the top of the unit lie down.
CHARGING
The device controls the charging status, the battery temperature and
power supply during the charging operation. The ideal temperature
range for charging is +10°...+30°C. If charging the battery above or
below these temperatures the life of a battery may be shortened. Also,
the battery may not reach full capacity. Battery charging with supplied
mains charger is not allowed below +0°C or above +40°C
When charging the Li-po batteries with the USB charger, about 70% of
the battery capacity will be charged quickly, but charging the remaining
30% takes relatively more time. Also note that humidity, temperature,
age of the battery and currently used features (e.g. the GPS) affect the
time spent on charging.
Standard CE-approved USB car charger ( 5VDC, 500mA ) may be
used for charging.
BATTERY CARE, MAINTENANCE AND DISPOSAL
The continuous operating time is less when using an old battery than a
new battery. When storing unit for a long time, it should be kept cool
and with fully charged battery in a dry place. Li-po batteries do not
contain heavy metals which can damage the environment. Li-po
batteries should be disposed of according to the country-specific
regulations.