Related Manuals for Wow Air Swimmers
Summary of Contents for Wow Air Swimmers
- Page 1 Instructions for assembly and flying of Shark & Clownfish* For easy to follow video instructions on assembling and flying your Air Swimmer go to www.wowstuff.co.uk/airswimmers *For the purposes of illustrations a Clownfish has been used...
- Page 2 Contents of Air Swimmers Clownfish Box 2 x Underbelly fins 1 x Back fin 1 x Air Swimmers Clownfish balloon 4 x Hooks 4 x Fastening clips Controller colour may vary 4 x Elastic bands 12 x Double sided sticky pads 1 x Tail fin...
- Page 3 Contents of Air Swimmers Shark Box 2 x Underbelly fins 1 x Back fin 1 x Air Swimmers Shark balloon 4 x Fastening clips 4 x Hooks Controller colour may vary 4 x Elastic bands 12 x Double sided sticky pads 1 x Tail fin...
- Page 4 IMPORTANT: PLEASE READ FULLY BEFORE ASSEMBLY THIS PRODUCT IS ONLY TO BE USED INDOORS Filling with helium Fill your Air Swimmer at most party shops, flower shops and good retail stockists. You may also buy your own helium tank that will allow you to fill your Air Swimmer at home.
- Page 5 Note. After a few days you may find that the Air Swimmer may lose some of its buoyancy, therefore you will need to top up the balloon on a regular basis. After several top ups the helium inside the balloon may become mixed with air and need to be emptied fully and then refilled.
- Page 6 Attaching the Pod Track 1. Attach the pod track (12) to the underside of the Air Swimmer balloon using double sided sticky pads (8). It helps to have another person hold the balloon upside down. Place the very back end of the track, at the track placement number shown below.
- Page 7 Assembly of the Tail motor unit 1. Using double sided sticky pads (8), stick the 4 hooks (6) onto the Air Swimmer. Make sure the arrow on the hook faces the towards the head of the Air Swimmer. 2. Place clear tape tabs (11A) over the hooks to secure.
- Page 8 5. Place the tail motor unit on the back of the Air Swimmer balloon and attach to the 4 hooks using the elastic bands (5). Make sure the plug connection on the tail motor unit, faces downwards. Plug connection 6. Plug the electric wire into the tail motor unit as shown.
- Page 9 2. Place clear tape tabs (11A) over the fin tabs to secure. Remote Control The remote control (9) requires 1 x 9V battery (13). 1. Unscrew the battery cover using a cross head screwdriver. Controller colour may vary 2. Insert the battery according to polarity shown.
- Page 10 Climb Controller colour may vary Controller colour may vary 3. To move the Air Swimmers tail left, press left on the remote. To move the tail right, press right on the remote. For easy to follow video instructions go to www.wowstuff.co.uk/airswimmers...
- Page 11 4. To get the Air Swimmer moving, you need to move the tail from left to right by pressing right, left, right, left in a constant rhythm. Experiment with faster and slower rhythms to find the best speed. 5. To turn the Air Swimmer push the button once in the direction you wish to turn. This will give you a tight turning circle, but the Air Swimmer will move slowly.
-
Page 12: Troubleshooting Guide
Troubleshooting guide Cause Solution Symptom My Air Swimmer will not float. Not enough helium or too much Refill with helium, remove putty so putty in the pod mouth. Air Swimmer balances around 5 ft in height High or low altitude Check your altitude and adjust the pod track accordingly. - Page 13 Warnings Clownfish: Operates on 40 MHz frequency Balloons represent a choking hazard. Keep uninflated balloons away from children. Discard broken balloons immediately. Children under 8 years can choke or suffocate. Warning! Never deliberately inhale balloon gas. Inhaling helium can result in serious lung injuries and/or suffocation. Do not inhale helium from a balloon or helium tank under any circumstances.
- Page 14 Warnings Shark: Operates on 27 MHz frequency Balloons represent a choking hazard. Keep uninflated balloons away from children. Discard broken balloons immediately. Children under 8 years can choke or suffocate. Warning! Never deliberately inhale balloon gas. Inhaling helium can result in serious lung injuries and/or suffocation. Do not inhale helium from a balloon or helium tank under any circumstances.
- Page 15 Declaration of Conformity Shark www.wowstuff.co.uk Manufacturer’s Name: China Industries Ltd. T/A Wow! Stuff! Manufacturer’s Address: Creative Industries Centre, Wolverhampton Science Park, Wolverhampton, WV10 9TG, UK Type of Equipment: Remote-Controlled Toy Model Number: AR-1001 Year of Manufacture: 2011 Application of Council Directive(s):...
Need help?
Do you have a question about the Air Swimmers and is the answer not in the manual?
Questions and answers